Read Sony SAL70200G2 Service Manual online
2-21
SAL70200G2 (2.8/70-200 G SSM Ⅱ) (70-200mm F2.8 G SSM II)
HELP39
1. Cut three polyester tapes (black) 10mm in the specified size and affix them to the locations indicated in the figure.
2. Install the focus rubber ring to the MF operation ring.
3. Fold up the 1st lens side of focus rubber ring.
4. Affix three SW flexible setting tapes as shown in the figure. (3 tapes on the circumference at the equal interval)
5. Peel the protection sheet off the contact side of SW flexible setting tape and fold the focus rubber ring back to the original position.
2. Install the focus rubber ring to the MF operation ring.
3. Fold up the 1st lens side of focus rubber ring.
4. Affix three SW flexible setting tapes as shown in the figure. (3 tapes on the circumference at the equal interval)
5. Peel the protection sheet off the contact side of SW flexible setting tape and fold the focus rubber ring back to the original position.
Polyester Tape
(Black) 10mm
(10X26mm)
(Black) 10mm
(10X26mm)
Polyester Tape
(Black) 10mm
(10X26mm)
(Black) 10mm
(10X26mm)
MF Operation Ring
1st lens side
SW Flexible
Setting Tape
Setting Tape
SW Flexible
Setting Tape
Setting Tape
SW Flexible
Setting Tape
Setting Tape
Keep off
2 to 3mm
from the end
2 to 3mm
from the end
The tape should not protrude from the
position lower than the out diameter
position lower than the out diameter
Fold up the focus rubber ring
as shown in the figure
as shown in the figure
HELP40
Anti-diffusion agent (A-20): J-6082-611-A
Grease (G-85): J-6082-626-A
Grease (G-85): J-6082-626-A
1. Apply the anti-diffusion agent (A-20) to the indicated area of MF operation ring.
2. Apply the grease (G-85) to the indicated area of MF operation ring.
2. Apply the grease (G-85) to the indicated area of MF operation ring.
Apply the anti-diffusion
agent (A-20)
(Around the hole)
agent (A-20)
(Around the hole)
Apply the
anti-diffusion
agent (A-20)
(All around)
anti-diffusion
agent (A-20)
(All around)
Inside
Outside
Inside
Outside
Cut
view
view
MF Operation Ring
Cut
view
view
Apply the
grease (G-85)
(All around)
grease (G-85)
(All around)
Apply the
grease 3mm
or more from
the end
grease 3mm
or more from
the end
HELP41
Adhesive bond (B-40): J-6082-614-A
1. Install the mirror tube block, aligning the index of mirror tube block with the focus stopper pin of outer tube as shown in the figure
below.
2. Apply two drops of adhesive bond (B-40) to six screws and tighten six screws to fix the mirror tube block.
Outer Tube
Focus Stopper Pin
Mirror Tube
Block
Block
Index
Apply the adhesive
bond (B-40)
bond (B-40)
Apply the
adhesive
bond (B-40)
adhesive
bond (B-40)
Click on the first or last page to see other SAL70200G2 service manuals if exist.