SAL70200G2 - Sony Digital Camera Service Manual (repair manual). Page 27

2-24

SAL70200G2 (2.8/70-200 G SSM Ⅱ) (70-200mm F2.8 G SSM II)

1.  Route the lead wires along the shape of Flexible BL PWB and fix it with the polyester tape (black) 4mm.
2.  Insulate the indicated portion of Flexible BL PWB.

  If the width of polyester tape is not enough, use two sheets of polyester tape.

Lead Wire (Red)

Lead Wire (Black)

Flexible BL PWB

Flexible BL PWB

Polyester Tape 
(Black) 4mm 
(4X15mm)

Polyester Tape 
(Black) 4mm 
(4X15mm)

Polyester Tape 
(12X30mm)

Polyester Tape 
(12X30mm)

Signal Box Block

Adhesive bond (B-10): J-6082-612-A

Install the main spring hook to the outside barrel, install the main spring as shown in the figure and apply the adhesive bond (B-10).

Apply the adhesive 
bond (B-10)

Apply the adhesive 
bond (B-10)

Apply the adhesive 
bond (B-10)

Main Spring 
Hook

Main Spring

Main Spring

Outside Barrel

Outside Barrel

Aperture Connect 
Lever

Adhesive bond (B-40): J-6082-614-A

Assemble the aperture connect lever in the preset ring, apply two drops of adhesive bond (B-40) to the tips of screws, tighten it with the
screws.
Note:

  Install the aperture connect lever and the preset ring so that they cross each other perpendicularly.

 

If the aperture connect lever leans, the aperture trouble (The blade remains.) occurs.

Aperture Connect Lever

Aperture Connect Lever

Apply the adhesive 
bond (B-40)

Preset Ring

Preset Ring