SAL70200G2 - Sony Digital Camera Service Manual (repair manual). Page 22

2-19

SAL70200G2 (2.8/70-200 G SSM Ⅱ) (70-200mm F2.8 G SSM II)

5.  Install the stator in the procedure below.

1)  Adjust the red index of mirror tube and the flexible PWB of stator to the locations respectively shown in the figure.
2)  Install the stator, aligning the rotation stopper pin with the stator groove.

Stator

Flexible PWB 
of stator

Flexible PWB 
of stator

Rotation 
Stopper Pin

Red index of mirror tube

Red index of mirror tube

Groove

When assembling rotor, never touch the resin coated surface (black coated side).
Note 1:

  If touched, wipe the resin coated surface of rotor with paper waste soaked with ethanol.

  The ultrasonic motor malfunctions due to finger grease, resulting in trouble.

 

When assembling, wear a finger tip.

Resin coated side 
(Black coated side)

Rotor

Grease (G-115): J-6082-627-A
Grease (G-117): J-6082-660-A

Apply the grease (G-115) and the following grease (G-A) to the indicated portion of rotor hold ring.
Grease (G-A) - (G-115: G117 = 1 : 2) (Before use, blend and mix well the greases in the ratio mentioned.)

Rotor Hold Ring

Apply the grease (G-A) 
(to all circumferences of bore)

Apply the grease (G-115)
(to all circumferences)

Affix the stator hold sheet B to the indicated location of outer tube.

Stator Hold 
Sheet B

Stator Hold 
Sheet B

Stator Hold Sheet B

Outer Tube

Outer Tube

Rotation Stopper Pin