SAL70200G2 - Sony Digital Camera Service Manual (repair manual). Page 28

2-25

SAL70200G2 (2.8/70-200 G SSM Ⅱ) (70-200mm F2.8 G SSM II)

1.  Install the SW1 shielding rubber and the SW2 shielding rubber, facing the adhesive side (ribbon-affixed side) to the SW1 and SW2.

SW1 Shielding 
Rubber

SW1 Shielding 
Rubber

SW2 
Shielding
Rubber 

SW1

SW1

Switch Cover

SW2

Install them, facing 
the adhesive sides 
(ribbon-affixed side)
to SW1 and SW2

Install the SW1 shielding 
rubber, facing the 
ribbon-affixed side to SW1.

2.  Install the click plate so that the side of vestige of eject pin faces toward you.

Click Plate

Vestige of eject pin

Vestige of eject pin

1.  Affix the SW flexible setting tape to the indicated location of switch base plate.
2.  Install the SW box flexible block to the switch base plate as shown blow.

SW Flexible Setting Tape

Switch Base Plate

SW Box Flexible Block

Affix it, pushing to 
the upper wall and 
left wall.

Affix it equally at 
right and left, 
pushing to the 
upper wall.

Affix it, pushing to 
the upper wall and 
right wall.

3.  Affix the SW flexible setting tape to the switch base plate as shown in the figure below.

Switch Base Plate

Switch Base Plate

Switch Base Plate

SW Box Flexible Block

Affix the SW flexible 
setting tape to the 
indicated position.

Affix the SW box 
flexible block, 
folding it.

Be careful for the SW 
box flexible block not to 
protrude at upper and 
lower sides.