Read Sony DSLR-A100 / DSLR-A100H / DSLR-A100K / DSLR-A100W (serv.man3) Service Manual online
6-37
DSLR-A100_ADJ
Fig. 1
CAMERA
Exposure mode: M
Focus mode: MF
Focus mode: MF
LENS
Master Lens for Shake
Frequency of 60 Hz: 300
±
5 r/min
Frequency of 50 Hz: 250
±
5 r/min
Control
Lens mount surface
1555
±
2 mm
Shake Offset Chart
II
25.
Adjustment of the camera shaking compensation (SHAKE GAIN)
Required equipment
Vibration tester
Shake offset chart II
PC with preinstalled the DSLR-A100 adjustment program
USB cable
AC adaptor/charger (AC-VQ900AM)
Master lens for shake
Shake offset chart II
PC with preinstalled the DSLR-A100 adjustment program
USB cable
AC adaptor/charger (AC-VQ900AM)
Master lens for shake
Preparation of the adjustment
1. Set the camera without USB cable and the measuring instrument as shown on the Fig. 1.
Set distance between camera and shake offset chart II to 1555
± 2 mm
Note 1:
Distance between camera and chart means distance between lens mount surface of the camera and chart. About lens mount
surface, refer to Fig. 1.
surface, refer to Fig. 1.
Note 2:
Use indirect lighting like room light for the lighting of the chart, not to use other direct lighting. If direct lighting is used,
adjustment error often happens because of the mis-detecting of the cross line of the chart.
adjustment error often happens because of the mis-detecting of the cross line of the chart.
2. Set the center of the camera finder to the center of the chart.
3. Confirm whether the center of the chart is located at the center of the screen or not by setting the camera to after view mode. If the
3. Confirm whether the center of the chart is located at the center of the screen or not by setting the camera to after view mode. If the
center of the chart is not located at the center of the screen, please perform setting again.
Procedure of the adjustment
1. Set camera to adjustment mode.
Refer to “Starting up the DSLR-A100 adjustment program (in the adjustment mode)”.
Attach the master lens for shake to the camera, and then set to the adjustment mode.
Confirm that the aperture value is not indicated as “--” on the LCD of the camera.
Attach the master lens for shake to the camera, and then set to the adjustment mode.
Confirm that the aperture value is not indicated as “--” on the LCD of the camera.
2. Click “SHAKE GAIN” of the adjustment menu. “Does it adjust?” appears.
3. Click “YES” then take a picture in the automatic mode.
4. Follow the message, “Please turn on shake!” Turn the power of the vibration tester on, and click “OK” after setting the rotation as
3. Click “YES” then take a picture in the automatic mode.
4. Follow the message, “Please turn on shake!” Turn the power of the vibration tester on, and click “OK” after setting the rotation as
follows (Fig.1). 8 or 4 pictures are automatically taken.
Frequency of 60 Hz: 300
± 5 r/min
Frequency of 50 Hz: 250
± 5 r/min
5. Follow the message, “Please turn off shake!” Turn the power of the vibration tester off, and click “OK” .
6. The adjustment is completed when “OK” is displayed on the adjustment menu.
6. The adjustment is completed when “OK” is displayed on the adjustment menu.
Click on the first or last page to see other DSLR-A100 / DSLR-A100H / DSLR-A100K / DSLR-A100W (serv.man3) service manuals if exist.