Read Sharp AR-D16 Service Manual online
AR-SP5 UNPACKING AND INSTALLATION 2 - 6
Turn the main switch to the “OFF” position and remove the power plug
from the outlet.
from the outlet.
1) Removing the cabinet cover.
<1> Ensure that the power switch on the unit is in the off position.
Remove the power cord from the power cord socket at the
rear of the unit.
rear of the unit.
<2> Remove the screw from the cabinet cover at the rear side of
the unit using the supplied screwdriver.
<3> Slide the cabinet cover in the direction indicated by the arrow
and pull the cover while raising it a little to remove it.
2) Installing the printer board.
<1> Remove the printer board from the protective bag.
<2> Insert the core as shown in the illustration.
<3> Install the printer board so that the parallel interface connec-
tor of the board is fitted into the hole for the connector.
(AR-PG2)
(AL-12PKM)
<4> Secure the printer board using the supplied five screws.
<5> Insert the cable into the printer board connector, with the side
with the blue parts facing right.
<6> Insert the core through to the middle position of the cable.
<7> Connect the board cable to the connector of the unit.
3) Replace the cabinet cover.
<1> Bend the end of the cabinet cover at the slit and break it off.
Caution: Take care in handling the cabinet cover because the
exposed edge could be sharp and may injure your
hands.
hands.
<2> Secure the cabinet cover using the screw which has been
removed.
Hole for the
connector
connector
Core
Hole for the
connector
connector
Printer board
connector
connector
Blue parts
(AL-12PKM)
(AL-12PKM)
Click on the first or last page to see other AR-D16 service manuals if exist.