AR-D16. Service manual - Sharp Copying Equipment Service Manual (repair manual). Page 4

AR-SP5  UNPACKING AND INSTALLATION  2 - 2

6) Attach the SPF rear cover.

<1> Pass the actuator of the book sensor into the hole of the SPF

rear cover and slide the SPF rear cover to attach it. At this
time, check that the pawl on the back side of the SPF rear
cover is inserted into the copier frame.

<2> Reattach the right glass holder to its original position and fix it

using the screw.

Note: Check that the actuator moves smoothly.

Take care to prevent entry of dirt into the scanner unit.

7) Attach the hinge guides L and R.

Attach the hinge guides L and R by fitting the pawls (two for each)
into the frame of the copier and secure them with the two screws
for each that have been removed in step 3.

8) Place the SPF on the copier.

9) Connect the SPF with the copier using the relay harness.

<1> Fit the snap band to the position shown in the illustration.

<2> Connect the connector.

<3> Fit the grounding terminal using the supplied screw (M3 

×

 8).

10) Attach the rear cabinet.

Remove the rib from the rear cabinet.

Note: While pushing down the actuator of the sensor unit, attach

the rear cabinet so that the actuator is inserted into the hole
of the rear cabinet.

<1> Hang the four pawls shown in the illustration below on the

plate.

<2> Push down the actuator of the sensor unit.

<3> Position the cabinet to the upper screw positions.

<4> Ensure that the actuator is inserted into the square hole of

the cabinet.

1

2

Pawls

Pawls

1

2

3

Pawl

Pawl

M3

×

8

M4

×

12

M3

×

8