AR-D16. Service manual - Sharp Copying Equipment Service Manual (repair manual). Page 12

AR-SP5  UNPACKING AND INSTALLATION  2 - 10

6) Check the contents of the package on the screen, and then click

the "Start" button.

The software packages to be installed will be displayed on the
screen. If inappropriate packages are displayed, click the "Back"
button to select only appropriate software packages.

7) Copying files for MFP driver installation and parallel interface setup

(This step will start if it was selected in step 4).

1.

After confirming the message in the "Welcome" window, click
the "Next" button.

2.

A dialog box appears asking you to verify that the USB or par-
allel interface cable is not connected to the MFP. Make sure
that the interface cable is not connected and click the "Next"
button.

3.

Click the "Next" button in the dialog box to install the MFP
driver or Cancel to quit the installation.

The setup program will start to copy the files.

In Windows 2000, if the following screen appears while the
files are being copied (the message may appear more than
once), click "Yes" in Windows 2000.

4.

The following screen appears. Click the "Yes" button, and then
the Model screen will appear. Select the model number that is
the same as the model name of your MFP and click the "Next"
button.

Be sure to select the displayed model number that is the same
as the MFP's model name. If they are not the same, the driver
will not be installed correctly.

5.

Establish the printer settings and click the "Next" button.

Select "LPT1" for the port to be used. If "LPT1" does not
appear, it is likely that another printer or peripheral device is
using "LPT1". Check your other printers and peripheral
devices, and change the port setting as needed so no device is
using "LPT1". If you wish the MFP to be your default printer,
select "Yes". If not, select "No".

6.

When the "Setup has completed gathering all necessary instal-
lation information" dialog box appears, click the "Yes" button.

The parallel interface driver is installed.

7.

When the "The MFP driver installation is complete." dialog box
appears, click the "OK" button.

The Sharpdesk installer will start.

8) Begin installation of the Sharpdesk (This step will start if it was

selected in step 4).

1. After confirming the message in the "Welcome to Sharpdesk

installation" window, click the "Next" button.

2. Read the message in the "Information" window, and then click

the "Next" button.

3. When the "Choose Destination Location" window appears,

click the "Next" button.

4. When the "Select Program Folder" window appears, click the

"Next" button.

The setup program will start to copy the files.

If the dialog box asking "If you have TIFF files saved using
Photo-Shop or Imaging for Windows you should hit Skip"
appears. Answer the question to continue the Sharpdesk
installation.

5. Click the "Finish" button when the message to inform you of

the completion of the installation appears.

9) Click the "Close" button when the message to inform you of the

completion of the installation appears.

• After the installation, a message to restart your computer may be

displayed. In this case, click the "Yes" button to restart your com-
puter.

10) Connect the parallel interface cable.

You have completed the installation of all the software.

• For parallel interface connection ensure that your computer and

MFP are turned off before connecting the cable (see page 5-8).