DV-NC65H (serv.man27). VCR Setup - Sharp DVD User Guide / Operation Manual. Page 14

38

www.sharp.co.uk/support

All the information you need on the VCR status will be summarised on the on-screen display. If you are record-
ing, playing back a tape or watching a broadcast on the video channel, you can call up three standard on-
screen displays. The display can be selected by pressing ON SCREEN on the Remote, 1, 2, 3 or 4 times.

• If the clock is not set, the time and date will not be displayed.

• When tape playback mode,”channel”is not displayed

Each time ON SCREEN on the Remote is pressed, the display on the TV screen changes the mode in the
following sequence:

• AUTO mode.................... The current mode and channel number will be displayed for 3 seconds when

an operation or number button is pressed.

• FULL mode .................... All the active features will also be shown on screen.

• Counter mode ................ This display will show the tape counter and amount of tape remaining.

• OFF mode ...................... This will remove the display from the screen.

Each time DISPLAY on the Remote is pressed, the VCR Front Panel Display changes the mode in the following
sequence:

• Clock mode..................... The current time will be displayed.

• Channel position mode..The channel position will be displayed.

*1

• Tape counter mode.........The current tape position will be displayed.

• Tape remain mode..........The amount of video tape remaining will be displayed.

• The default time and date will not be displayed if the clock has not been set.

• The VCR will return to Tape counter mode each time it is switched on.

recorded.

• When power ON, channel position is displayed.

• Usually use the “channel position”.

AUTO mode 

→ FULL mode → Counter mode → OFF mode

Clock mode 

→ Channel position mode*1 → Tape counter mode → Tape remain mode

          

                 1 CH59
SUPER P. ON       NICAM
                  STEREO
SP                   L R

10:00AM      REM  1:05
9/07 02           0:00.00

Programme number and channel

Tape Status

NICAM signal

Audio output mode

Tape speed

Tape remaining

Time

Date

Tape counter

Select VCR/DVD CHANGE Switch to VCR.

Press OPERATE.

Press and hold VCR MENU and CH " together on the Remote
Control for 10 seconds.

• VCR reset is now complete.

*1  When in tape playback
      mode, “channel” is not
      displayed

DVNC65H028_038.pm6

30/8/02, 11:34 am

38