Read JBL BASSPRO (serv.man6) User Guide / Operation Manual online
BassPro has been designed to deliver
great bass performance from a compact,
easily installed powered subwoofer
BassPro, we strongly recommend that
installation be entrusted to a qualified
professional. Although these instructions
explain how to install BassPro in a
general sense, they do not show specific
installation methods that may be required
for your particular vehicle.
If you do not have the necessary tools
or experience, do not attempt the
installation yourself. Instead, please
ask your authorized JBL car audio
dealer about professional
you should you require warranty
service, please retain your
original sales receipt and register your
BassPro online at www.jbl.com.
hinder your ability to hear traffic and
permanently damage your hearing.
We recommend listening at low or
moderate levels while driving your car.
JBL accepts no liability for hearing loss,
bodily injury or property damage
resulting from the use or misuse of this
WARNINGS AND TIPS:
that screws or wires will not puncture
brake lines, fuel lines or wiring
harnesses, and that wire routing will
not interfere with the safe operation of
current rating as that of the original.
interfere with cargo, the fold-down rear
seat or the trunk lid. The best location is
usually a corner of the trunk or cargo
area, as shown in Figures 1 and 2.
mounting surface using the four
enclosed self-tapping screws.
of the vehicle for the remote level
LEVEL CONTROL TO BASSPRO
mounted under the dash or dismantled
and mounted in the dash for a factory-
easy access to the control while driving.
Using the Subwoofer Level Control as a
template, mark and drill holes in the
mounting surface. Attach the
Subwoofer Level Control using the
mounting screws provided (Figure 4).
Control by removing the two Phillips-
head screws on the front panel,
rear panel and on top. Remove the
Subwoofer Level Control’s bottom and
side panels. Slide the Subwoofer Level
Control’s PC board forward to release
the RJ11 connector from the back panel
and remove the board along with the
potentiometer, knob and connector as a
easy access to the control, and
provides 1-3/4" clearance behind the
mounting surface. Drill a 9/32" hole in
the mounting surface. Feed the
Subwoofer Level Control’s potentiome-
ter shaft (with the knob removed)
through the hole and use the nut and
washer provided to hold the control in
place (Figure 5).
other interior panels and under the
carpet. Do not route the cable outside
the vehicle. Connect the RJ11 cable
between the RJ11 receptacle on the
BassPro and the receptacle on the
Subwoofer Level Control (Figure 6).
Subwoofer Level Control.
Subwoofer Level Control.
shown in Figure 7. Please observe
the following installation tips:
connections, BassPro will automatically
turn on when you turn on your radio.
In this case, the remote (REM)
connection is not needed. Use at least
#20 AWG speaker wire for speaker-level
Positive Battery (BATT +12) and Ground
terminal directly to the battery’s positive
(+) terminal. Install a fuse holder, with a
20A fuse, within 18" of the battery’s
positive (+) terminal.
grommet in the vehicle’s firewall. If a
factory grommet is not available, install
Connect a short ground wire from
BassPro’s ground terminal ( ) to the
nearest bare metal surface. For a good
connection, use sandpaper to clear
paint from the metal surface and use
a screw with a lock (star) washer.
a +5 to +12 Vdc signal for BassPro
to turn on when using the line-level
connections. Most head units with
preamp outputs provide this remote
voltage signal. As an alternative,
connect this terminal to a switched