Read JBL ON STAGE III IIIP (serv.man2) EMC - CB Certificate online
<12014238 001 >
Page 21 of 77
IEC 60950-1 / EN 60950-1
Clause
Requirement – Test
Result – Remark
Verdict
TRF No.:IECEN60950_1B
TRF originator: SGS Fimko
4.7.3.4
Materials for components and other parts inside
fire enclosures
fire enclosures
P
4.7.3.5
Materials for air filter assemblies
No air filters provided.
N/A
4.7.3.6
Materials used in high-voltage components
No high voltage components
provided.
provided.
N/A
5
ELECTRICAL REQUIREMENTS AND SIMULATED ABNORMAL CONDITIONS
P
5.1
Touch current and protective conductor current
P
5.1.1
General
See sub-clauses 5.1.2 to 5.1.6.
P
5.1.2
Equipment under test (EUT)
EUT has only one mains
connection.
connection.
P
5.1.3
Test circuit
Equipment of figure 5A used.
P
5.1.4
Application of measuring instrument
Using measuring instrument in
annex D.
annex D.
P
5.1.5
Test procedure
The touch current was
measured from mains to DC
output connector and to a 100
mm × 200 mm metal foil
wrapped on accessible non-
conductive parts (plastic
enclosure).
measured from mains to DC
output connector and to a 100
mm × 200 mm metal foil
wrapped on accessible non-
conductive parts (plastic
enclosure).
P
5.1.6
Test measurements
See below.
P
Test voltage (V) ...................................................: See appended table 5.1.6.
Measured touch current (mA) ..............................: See appended table 5.1.6.
Max. allowed touch current (mA) .........................: See appended table 5.1.6.
Measured protective conductor current (mA) ......:
Max. allowed protective conductor current (mA) .:
5.1.7
Equipment with touch current exceeding 3.5 mA : Neither stationary permanently
connected equipment nor
stationary pluggable equipment
type B.
stationary pluggable equipment
type B.
N/A
5.1.8
Touch currents to and from telecommunication
networks and cable distribution systems and from
telecommunication networks
networks and cable distribution systems and from
telecommunication networks
No TNV.
N/A
5.1.8.1
Limitation of the touch current to a
telecommunication network and a cable
distribution system
telecommunication network and a cable
distribution system
N/A
Test voltage (V) ...................................................:
Measured touch current (mA) ..............................:
Max. allowed touch current (mA) .........................:
5.1.8.2
Summation of touch currents from
telecommunication networks ................................:
telecommunication networks ................................:
N/A
Click on the first or last page to see other ON STAGE III IIIP (serv.man2) service manuals if exist.