Read Harman Kardon HK 970 (serv.man13) EMC - CB Certificate online
Page 12 of 66
Report No.: HK-R04173361
IEC 60065 / EN 60065
Clause
Requirement – Test
Result - Remark
Verdict
TRF No: IECEN60065D
Intertek Testing Services Hong Kong Ltd.
2/F., Garment Centre, 576 Castle Peak Road, Kowloon, Hong Kong.
Tel: (852) 2173 8888 Fax: (852) 2785 5487 Website: www.hk.intertek-etlsemko.com
8.17
Insulated winding wire without additional
interleaved insulation
interleaved insulation
No such wire
N
8.18
Endurance test as required by 8.17
N
8.19
Disconnection from the mains
8.19.1
Disconnect device
Mains plug used and complied
with clause 5.4.2(a)
with clause 5.4.2(a)
P
All-pole switch or circuit breaker with
≥3mm
contact separation
No such device
N
8.19.2
Mains switch ON indication
No such device
N
8.20
Switch not fitted in the mains cord
N
8.21
Bridging components comply with clause 14
No such component
N
9
ELECTRIC SHOCK HAZARD UNDER NORMAL OPERATING CONDITIONS
9.1
Testing on the outside
9.1.1
For voltages >1000 V ac or >1500 V dc complies
with clause 13.3.1 for basic insulation
with clause 13.3.1 for basic insulation
No such circuit
N
9.1.1.1
Touch current measured from terminal devices
using the network in annex D ................................ :
using the network in annex D ................................ :
Measured maximum:
U1: 314,0mV peak < 35Vpeak
U2: 22,8mV peak < 0,35Vpeak
U1: 314,0mV peak < 35Vpeak
U2: 22,8mV peak < 0,35Vpeak
P
Discharge not exceeding 45 µC
Measured discharge: 47,3nC
P
Energy of discharge not exceeding 350 mJ
Open circuit voltage < 15kV
N
9.1.1.2
Test with test finger and test probe
No hazardous live parts
became accessible
became accessible
P
9.1.2
No hazardous live shafts of knobs, handles or
levers
levers
N
9.1.3
Ventilation holes and other holes tested by means
of 4 mm x 100 mm test pin
of 4 mm x 100 mm test pin
Top ventilation holes < 4mm
N
9.1.4
Terminal devices tested with 1 mm x 20 mm test
pin (10 N); test probe D of IEC 61032
pin (10 N); test probe D of IEC 61032
P
Terminal devices tested with 1 mm x 100 mm
straight wire (1 N); test probe D of IEC 61032
straight wire (1 N); test probe D of IEC 61032
P
9.1.5
Pre-set controls tested with 2,5 mm x 100 mm test
pin (10 N); test probe C of IEC 61032
pin (10 N); test probe C of IEC 61032
No such device
N
Click on the first or last page to see other HK 970 (serv.man13) service manuals if exist.