MHS-TS55 (serv.man2) - Sony Movie Service Manual (repair manual). Page 7

MHS-TS55_ADJ

5-7

The adjustment is finished abnormally.

Malfunction of Lens
shading adjustment result

The Lens shading adjustment order is as follows.

Note:
Perform this adjustment after those performed in 5-3-3 to 5-3-6.

Small pattern box (PTB-1450) setting: 
Color temperature = 3100 ± 200K
Luminance: LV12.2 ± 0.5

The adjustment is finished normally.

The adjustment is complete.

Confirm the indication

on the screen.

Finished abnormally.

Finished normally.

In case of the adjustment is finished abnormally,
the following indication appears on the screen.
(Fig. 5-3-20)
In this case, confirm the adjusting environment
and readjust.

Touch the Left area, Right area, or the Top area, Bottom area on the LCD screen to choose an adjustment item.
Select “

Lens Shad (LV10)”, and touch the Center area on the LCD screen.

Select “OK”, and touch the Center area of the LCD screen to start.
* If the adjustment is disabled, refer to “5-1-6. Enabling the Adjustment” to enable the adjustment. (Page 5-3)

In case of the adjustment is finished normally,
the adjustment completion indication appears
on the screen. (Fig. 5-3-19)
Press the

(Shutter) button

to return to

adjustment menu.

Check that the camera is on the adjustment mode.

* For the setting procedure of the adjustment mode, refer to “5-1-5. Setting the Adjustment Mode” (Page 5-3).

Place the camera in front of the Small pattern box (PTB-1450). (Fig. 5-3-18)

Touch the Left area, Right area, or the Top area, Bottom area on the LCD screen to choose an adjustment item.
Select

“Lens Shad (LV10)”, press the

(Shutter) button, then confirm that the value of “Lsd/Flash” is set as “002”.

Adjustment order

Screen display

Finish all of the adjustment except for the Language destination setting.
Once the Language destination setting is finished, it cannot be reset. 

USB Driver and Service Tool
Put the two folders “USB Driver” and “Service Tool” downloaded in “5-1-5. Setting the Adjustment Mode” (Page 5-3) in any place of the PC.

The procedure of installing a USB driver is as follows.
1)  Execute the “DirectUSB-Setup.exe” in the “USB Driver” folder to start up the Installer.
2)  Install the USB driver according to the guidance on the screen.
3)  Connect the camera started up with the adjustment mode, and the PC with a USB extension cable.
4)  Adapt the USB driver installed in step 2) according to the guidance on the screen.

Connecting USB to PC
Connect the equipments as shown below. (Fig. 5-3-21)

USB extension cable

Insert all the way

(A plug to A socket)
(Commercially available)

Execute the “ServiceTool_Ver[][][].exe” in the “Service Tool” folder to start up the Service Tool. (Fig. 5-3-22)

Small pattern box
(PTB-1450)

5 mm or less

Black cloth

Camera

Equipments required: Small pattern box (PTB-1450)

Cover camera lens and
Small pattern box (PTB-1450)

(All black)

Clear chart