Read Sony SAL300F28G Service Manual online
HELP
SAL300F28G (2.8/300 G) (300mm F2.8 G)
HELP09
Grease (G-85): J-6082-626-A
Adhesive bond (LOCTITE 460)
Note:
Use the adhesive bond (LOCTITE 460) or the equivalent.
Do not use the instant glue, which becomes white after dried.
1.
Apply two drops of adhesive bond (LOCTITE 460) to the tip of stopper screw and tighten it to the mount.
2.
Apply the grease (G-85) the indicated portion of mount.
HELP10
Adhesive bond (LOCTITE 460)
Note:
Use the adhesive bond (LOCTITE 460) or the equivalent.
Do not use the instant glue, which becomes white after dried.
1.
Cut the back adjustment washer (t=0.1mm) as indicated in the figure. (About 10mm)
2.
Affix the back adjustment washer to the indicated position of iris holding tube block, using the adhesive bond (LOCTITE 460).
Note:
Apply a little amount of adhesive bond (LOCTITE 460) on the backside of parts made by cutting the back adjustment
washer as indicated. And affix them, aligning the screw holes.
Apply the adhesive bond (LOCTITE 460)
Apply the grease
(G-85)
(G-85)
Apply the grease
(G-85)
(G-85)
Back side of claw
(3 locations)
(3 locations)
Entrance
side
side
Entrance
side
side
Entrance
side
side
Entrance
side
side
Stopper Screw
Mount
Mount
Approx. 3 – 5mm
Inside
Outside
Cut
view
view
Cut
view
view
Back Adjustment Washer
(t=0.1mm)
(t=0.1mm)
Back Adjustment Washer
(t=0.1mm)
(Already cut one)
(t=0.1mm)
(Already cut one)
Iris Holding Tube Block
Approx. 10mm
Approx.
10mm
10mm
Cut the broken lines
to make parts.
(4 pieces)
to make parts.
(4 pieces)
Approx.
10mm
10mm
Approx.
10mm
10mm
Apply the adhesive
bond (LOCTITE 460)
(Back side)
bond (LOCTITE 460)
(Back side)
Click on the first or last page to see other SAL300F28G service manuals if exist.