MX-LC13 (serv.man15). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 25

MX-7040N  MX-LC13 (LARGE CAPACITY TRAYS)  8 – 6

NOTE: Avoid bending paper with too much closing the regulation

plates.

NOTE: When shifting the line of printing from the center of the

paper to rear side, move the front regulation plate to adjust
it.

1) Run Sim50-10 using the keypad on the main unit.
2) This screen allows you to configure the print off-center adjust-

ment value for each paper feed tray.

3) On the touch panel, press [DOWN] Key to select "H: 50:

MAINLCT1."

4) Enter the desired adjustment value through the numeric key-

pad. (This value, which defaults to 50, can be adjusted within
the range of 1 to 99)

-    Reducing the adjustment value by 1 causes the main scan/

print position to shift by 0.1mm toward the rear.

-    Increasing the adjustment value by 1 causes the main scan/

print position to shift by 0.1mm toward the front.

5) After entering the adjustment value, press the [EXECUTE] key

on the touch panel to start printing and save the setting.

6) Check that the adjustment pattern image is printed in the cor-

rect position.
Measure the dimensions of the void areas on the front and rear
frame sides of the adjustment pattern image, and make sure
that the following conditions are met:

No adjustment is needed if A-B=+/-3.0 mm.
If the above condition is not met, do the following:

7) Change the adjustment value. (Enter the adjustment value and

press the [OK] key.)
Changing the adjustment value by 1 shifts the position by
approximately 0.1 mm. 
Repeat steps 4) to 6) until the condition shown in step 6) is sat-
isfied. 

8) After you have completed the adjustment, exit from Simulation

mode by pressing the [CA] key.
MEMO：For details of the adjustment and checking proce-
dures, refer to the "[5] ADJUSTMENTS AND SETTINGS" on
the Service Manual.

1)

Pull out the cassette.
Press the lock button on the front cabinet and lower the paper
feed base tray to the paper supply position. Pull out the tray.
* In case the machine is turned off, If it is necessary to release
the lock manually, push the shaft at the bottom of the front cab-
inet and lower the paper feed base tray to the paper supply
position and pull out the tray. 

2)

Adjust the diagonal feed.

3)

Set a sheet of paper on the paper feed base tray and adjust
the width of the regulation plate.
In the case of diagonal feed 1
Loosen the 2 blue screw (1) on the front regulation plate.
Referring to the degree of diagonal feed, move the regulation
plate in the clockwize direction and fix the blue screw.

Loosen the 2 blue screws (2) on the rear regulation plate.
To make parallel with the front regulation plate, move the rear
regulation plate in the clockwize direction and fix the screws.

MM

3DSHU

!

"

3ULQWHGVXUIDFH

3DSHUGHOLYHU\
GLUHFWLRQ

$% PP

5HDU6LGH

)URQW6LGH

$%
PP0HFKDQLFDODGMXVWPHQWPP
0HFKDQLFDODGMXVWPHQW

Diagonal feed 1

Diagonal feed 2

Transport 
direction

)URQW

3DSHU

5HDU

5HJXODWLRQ3ODWH

TopPage

: ‘14/Jan