MX-LC13 (serv.man15). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 29

MX-7040N  MX-LC13 (LARGE CAPACITY TRAYS)  8 – 10

If “Off-center” is over +/-3mm.
1) Open the left side door and the LCT delivery paper guide unit.

2) Loosen the 2 blue screws.

3) Adjust the LCT position to push or pull with holding the pillar of

LCT as the figure below.
In case the print image shifts to front: Push LCT to rear
direction.
In case the print image shifts to rear: Pull LCT to front direc-
tion.
After finish the adjustment, fix the unit with the 2 blue screws.

If these adjustment above couldn’t adjust Off-center completely, the
following adjustment is needed.
When shifting the line of printing from the center of the paper in the
direction A of arrow as shown below:
1)

Separate the LCT from MX-RB14.
When separating, tighten the screw to release the lock. 
When connecting again, loosen the screw after connection.

2)

Open the left side door and open the LCT delivery paper guide
unit.

3)

Loosen the 2 blue screws.

4)

Shift the connection unit to the following direction and fix the 2
blue screws.

In case the print image shifts to front;
- Shift the Connection plate unit to the front.
In case the print image shifts to rear: Use F hole.
- Shift the Connection plate unit to the rear.

5)

To stick the L-shape driver (Packed items No.12) to the adjust-
ment hole, the connection plate unit position can be adjusted
to the following 4 steps.
F1.5 / 3 : Shift the unit 3 / 1.5 mm to front.
R1.5 / 3 : Shift the unit 3 / 1.5 mm to rear.

&RQQHFWLRQSODWHXQLW

5

)

5

)