MX-LC13 (serv.man15). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 24

MX-7040N  MX-LC13 (LARGE CAPACITY TRAYS)  8 – 5

3) Check the void area of the adjustment pattern and check the

“Off-center” shift amount (A-B).
“A-B” is over 3mm: Move to Mechanical Adjustment 1
“A-B” is less than +/-3mm: Move to Mechanical Adjustment 2

When shifted over +/-3mm.
1) If the image shifts to the front side, lift up the front side adjuster

in order to correct the paper transport position as a figure
below.

2) If the image shifts to the rear side, lift up the rear side adjuster

in order to correct the paper transport position as a figure
below.

When shifted over +/-2mm less than +/-3mm.
1)

Pull out the cassette.
Press the lock button on the front cabinet and lower the paper
feed base tray to the paper supply position. Pull out the tray.
* In case the machine is turned off, If it is necessary to release
the lock manually, push the shaft at the bottom of the front cab-
inet and lower the paper feed base tray to the paper supply
position and pull out the tray. 

When shifting the line of printing from the center of the paper in
the direction A of arrow as shown below:

2)

Loosen the blue screws of the rear regulation plate, and move
the plate with referring the carved marks by the dimension
shifted in the direction A (R side), and tighten the blue screws.

3)

Set a sheet of paper on the paper feed base tray and loosen
the blue screws of the front regulation plate.
Move the front regulation plate to the direction A (R side) with
pushing paper to the front regulation plate.

!

"

3ULQWHGVXUIDFH

3DSHUGHOLYHU\
GLUHFWLRQ

,IWKHGLPHQVLRQRI%LVELJ͆2IIFHQWHU͇
VKLIWGLUHFWLRQLVUHDUGLUHFWLRQ

,IWKHGLPHQVLRQRI$LVELJ͆2IIFHQWHU͇
VKLIWGLUHFWLRQLVIURQWGLUHFWLRQ

5HDU6LGH

)URQW6LGH

$%
PP0HFKDQLFDODGMXVWPHQWPP0HFKDQLFDODGMXVWPHQW

5HDU

%OXH6FUHZV

5HJXODWLRQ3ODWH

)URQW

3DSHU

3XVKSDSHUWRWKHIURQW
UHJXODWLRQSODWH