AR-FX10. Service manual - Sharp Copying Equipment Service Manual (repair manual). Page 9

AR-FX10  UNPACKING AND INSTALLATION  5 - 1

Turn the power switch located on the left side of the printer to the
"OFF" position.

Then remove the power plug of the main unit from the outlet.

1) Loosen the rear cabinet securing screw.

2) Remove the three rear connecting cabinet securing screws

and lift the rear connecting cabinet to remove it taking care
about the engagement with the rear cabinet.

3) Peel the securing tape of the FAX interface cable stored in

the printer and pull out the cable from the wire saddle.

Attach the supplied snap band to the fax interface cable as shown
in the illustration and fit the snap band into the hole of the OP
connector mounting plate. 

Pull the interface cable gently to your side to check that the snap
band is secured to the OP connector mounting plate and that the
snap band on the cable is not loosened.

Then, cut off unnecessary portions with nippers.

1) Cut out the cut-out portion.

2) Pass the fax interface cable through the cut-out portion and

attach it to the rear connecting cabinet taking care about the
engagement with the rear cabinet.

3) Secure the cabinet with two screws at the two positions

shown in the illustration.

4) Tighten the rear cabinet securing screw that has been loos-

ened at 1) in step (2).

1) Remove the two rear cabinet securing screws.

2) Use the two screws that have been removed to secure the fax

box mounting plate (for main unit) with the rear cabinet.

 Fax box mounting plate 
(for main unit): 1 pc.

Screw B: 1 pc.

Snap band: 1 pc.

Operation manual: 

1 volume

U.K

France

Germany

Australia

For other
 destinations

Wire saddle

Snap band