Read Sharp AR-FN2 (serv.man2) Service Manual online
Insert the power plug of the copier to an outlet, turn
the power switch to the "ON" position and then
perform the following procedure.
the power switch to the "ON" position and then
perform the following procedure.
Finisher operation check
·
Check the operation in the staple mode.
Make 10 copies in the staple mode and check that the copies are
stapled properly.
stapled properly.
If the copies are not stapled at this time, use the following proce-
dure to feed staples to the tip.
dure to feed staples to the tip.
1. Open the stapler cover of the finisher.
2. Remove the staple cartridge.
Raise the staple cartridge release lever of the stapler unit to re-
move the staple cartridge.
move the staple cartridge.
3. Close the stapler cover of the finisher and remove the copies.
After removing the staple cartridge, close the stapler cover of the
finisher.
finisher.
Then remove the copies from the finisher.
4. Check the staple cartridge.
Check that the first staple is at the STAPLE TEAR line of the
cartridge before setting the cartridge.
cartridge before setting the cartridge.
·
If the first staple does not reach the STAPLE TEAR line, pull it
to the line.
to the line.
·
If the first staple protrudes past the STAPLE TEAR line, tear
the staples and align the first staple with the line.
the staples and align the first staple with the line.
5. Set the staple cartridge.
Open the stapler cover of the finisher and set the staple cartridge
in the stapler unit.
in the stapler unit.
Insert the cartridge securely until it clicks.
Close the stapler cover.
Installation of the finisher is now complete.
STAPLE
TEAR line
TEAR line
(1)
(2)
1 – 5
