Read Sharp AR-FN2 (serv.man2) Service Manual online
2. Installation
Before installation, check that the following parts are included in the
package.
package.
Unplug the copier’s power cord before carrying out
the following procedure.
the following procedure.
Carry out the following steps before installing the
AR-FN2.
AR-FN2.
1. Pull out the exit unit of the copier until it stops.
2. Remove the two exit area cover fixing screws and remove the exit
area cover.
3. Remove the two transport springs that are attached to the exit
paper guide.
4. Store the two removed transport springs by hanging on the exit
unit front frame (position in Fig. 1).
5. Reattach the exit area cover to its original position and secure it
using two fixing screws.
6. Insert the exit unit into the copier.
1. Attach the connecting plate to the finisher.
Insert the connecting plate into the lower part of the finisher and
secure it using two screws A.
secure it using two screws A.
2. Attach the paper holder lever.
Attach the paper holder lever by inserting it into the mounting location
of the finisher as shown in the figure.
of the finisher as shown in the figure.
3. Attach the exit tray and tray 2.
Insert tray 2 securely into the tray mounting stand and secure it using
one screw A. Then attach the exit tray to the finisher by inserting boss
at (1) first.
one screw A. Then attach the exit tray to the finisher by inserting boss
at (1) first.
Parts included
Tray 2: 1
Connecting plate: 1
Positioning screws: 2
Exit tray: 1
Paper holder lever: 1
Screws A: 3
Screws B: 2
Lock plates: 2
Stapling position label A: 1
Stapling position label B: 1
Screws C: 2
[Fig. 1]
Exit unit
Fixing screw
Exit area cover
Fixing screw
Transport spring
Screws A
Connecting plate
Paper holder lever
Tray 2
Exit tray
Screw A
(2)
(1)
1 – 2
Click on the first or last page to see other AR-FN2 (serv.man2) service manuals if exist.