Read Sharp AR-FN2 (serv.man2) Service Manual online
<2> Push the finisher into the copier.
At this time, check to see if the clearance between the lower
part of the finisher and the copier is approximately 1 mm (small
clearance).
part of the finisher and the copier is approximately 1 mm (small
clearance).
If the finisher touches the copier or the clearance is too large:
Adjust the clearance by rotating the adjusting screw that is attached
to the paper exit side of the lower part of the finisher (Fig. 2).
to the paper exit side of the lower part of the finisher (Fig. 2).
·
If the finisher touches the copier or the finisher is not locked:
Rotate the adjusting screw clockwise so that the clearance be-
tween the lower part of the finisher and the copier is approximately
1 mm.
tween the lower part of the finisher and the copier is approximately
1 mm.
·
If the clearance is too large:
Rotate the adjusting screw counter-clockwise so that the clearance
between the lower part of the finisher and the copier is approxi-
mately 1 mm.
between the lower part of the finisher and the copier is approxi-
mately 1 mm.
8. Stick a stapling position label.
For document cover
For SPF
For ADF/RADF
Approximately 1 mm
Adjusting screw
[Fig. 2]
Stapling position label A
Stapling position label A
Stapling position label B
1 – 4
Click on the first or last page to see other AR-FN2 (serv.man2) service manuals if exist.