AR-122E (serv.man14). Sect 5. Unpacking Installation - Sharp Copying Equipment Service Manual (repair manual). Page 4

AR-122E/152E/153E/157E  UNPACKING AND INSTALLATION  5 - 4

Note: This copier is equipped with two paper trays. Load copy paper

into the two paper trays.

1) Raise the handle of the paper tray and pull the paper tray out until

it stops.

2) Remove the pressure plate lock. Rotate the pressure plate lock in

the direction of the arrow to remove it while pressing down the
pressure plate of the paper tray.

3) Store the pressure plate lock that was removed in step 2 and the

screw that was removed when unpacking the machine in the front
of the paper tray. To store the pressure plate lock, rotate the lock
to fix it on the relevant location.

4) Adjust the paper guides on the paper tray to the copy paper width

and length.
Squeeze the lever of paper guide (A) and slide the guide to match
with the width of the paper.
Move paper guide (B) to the appropriate slot as marked on the
tray.

5) Fan the copy paper and insert it into the tray. Make sure the edges

go under the corner hooks.

Note: Do not load paper above the maximum height line (

).

Exceeding the line will cause a paper misfeed.

6) Gently push the paper tray back into the copier.

restarting copying, press the clear (

) key. The "P" in the

display will go out and the ready (

) indicator will light up.

1) Ensure that the power switch of the copier is in the OFF position.

Insert the attached power cord into the power cord socket at the
rear of the copier.

2) Plug the other end of the power cord into the nearest outlet.

When moving the unit, follow the procedure below.

Note: When moving this unit, be sure to remove the TD cartridge in

advance.

1) Turn the power switch off and remove the power cord from the out-

let.

2) Open the side cover and front cover, in that order. Remove the TD

cartridge and close the front cover and side cover, in that order.

To open and close the side cover and front cover, and to remove
the TD cartridge, see "TD CARTRIDGE REPLACEMENT".

3) Raise the handle of the paper tray and pull the paper tray out until it

stops.

4) Push the center of the pressure plate down until it locks in place

5) Push the paper tray back into the unit.

6) Lock the scan head locking switch.

Note: When shipping the unit, the scan head locking switch must be

locked to prevent shipping damage.

7) Close the multi-bypass tray and the paper output tray extension,

and attach the packing materials and tape which were removed
during installation of the unit. See "PREPARING THE UNIT FOR
INSTALLATION".

8) Pack the unit into the carton. See "CHECKING PACKED COMPO-

NENTS AND ACCESSORIES".

Paper 
guide  (B)

Paper 
guide  (A)