Read Sharp AM-400 (serv.man8) Service Manual online
AM-400DE
2 – 14
3.6.3 Bypass temp.
This mode is used to set the temperature of fixing when printing from
the bypass tray.
the bypass tray.
1. ON TEMP.
The temperature to start turning on the heater.
• Default value: 200
• Range: MIN: 170, MAX: 233
• Unit: Centigrade
2. OFF TEMP.
The temperature to start turning off the heater.
• Default value: 200
• Range: MIN: 170, MAX: 233
• Unit: Centigrade
3. FEED TEMP.
The temperature to start feeding the paper.
• Default value: 200
• Range: MIN: 170, MAX: 233
• Unit: Centigrade
4. TIME
Warming up time after reaching the temperature that the printing
can be done.
can be done.
• Default value: 10
• Range: MIN: 10, MAX: 63
• Unit: Second
3.6.4 Flicker adjust
This mode is specified the number of table for the countermeasures of
“FLICKER”.
“FLICKER”.
• Default value: 06
• Input Range: MIN: 00, MAX: 63
• Unit: -
3.6.5 Parameter list
Printing the parameter for fixing.
3.7. Test mode
This mode is used for printer aging on the two modes.
3.7.1 Motor aging
1. The motor aging starts with heater on or with heater off.
2. To exit the aging, press [STOP] key.
3.7.2 Charger adjust
This mode is used to check the high-pressure control.
1. Operation
1. Press the [ENTER] key to operate the mode.
2. Press the [STOP] key to exit this mode.
3.7.3 Paper feed
This mode is used to check Mechanical Controller in the High speed
mode.
mode.
Note: This mode is not used actual printing.
1. Operation
1. Press the [ENTER] key to operate the mode.
2. Press the [STOP] key to exit this mode.
[>]Key
BYPASS TEMP.
ON temp.=200 deg
OFF temp.=200 deg
FEED temp.=200 deg
TIME=10(s)
[ENTER]Key
[>]Key
[>]Key
[>]Key
Input temperature using the numeric keys
Input temperature using the numeric keys
Input temperature using the numeric keys
Input temperature using the numeric keys
FLICKER ADJUST
[ENT ER]K ey
FLICKER NO.=06
PARAMETER LIST
[ENT ER]K ey
PRINTING
TEST MODE
[ENTER]Key
1: MOTOR AGING
2: CHARGER ADJUST
[>]Key
[>]Key
3: PAPER FEED
[>]Key
5: PRINT SIZE
[>]Key
4: COM TEST
[>]Key
1: MOTOR AGING
[ENTER]Key
HT 1: ON 2: OFF
MM_AGING: HT_ON
MM_AGING: HT_OFF
[1]Key
[2]Key
2: CHARGER ADJUST
[ENTER]Key
NOW ADJUSTING
3: PAPER FEED
[ENTER]Key
NOW AGING
Click on the first or last page to see other AM-400 (serv.man8) service manuals if exist.