Read Sharp AM-400 (serv.man8) Service Manual online
AM-400DE
2 – 31
[4] Error code table
1. Communication error code table
1.1. G3 Transmission
1.2. G3 Reception
1.3. Super G3 mode
1.4. <Reference> Details of E-29 ~ E31
Code
Final received signal
Error Condition (Receiver side)
0
Incomplete signal frame
Cannot recognize bit stream after flag
1
NSF, DIS
Cannot recognize DCS signal by echo etc.
Cannot recognize NSS signal (FIF code etc.)
Cannot recognize NSS signal (FIF code etc.)
2
CFR
Disconnects line during reception (carrier missing etc.)
3
FTT
Disconnects line by fall back
4
MCF
Disconnects line during reception of multi page
Cannot recognize NSS, DCS signal in the case of mode change
Cannot recognize NSS, DCS signal in the case of mode change
5
PIP or PIN
6
RTN or RTP
Cannot recognize NSS, DCS signal after transmit RTN or RTP signal.
7
No signal or DCN
No response in receiver side or DCN signal received* (transmitter side)
8
-
Owing to error in some page the error could not be corrected although the specified number of
error retransmissions were attempted.
error retransmissions were attempted.
11
-
Error occurred after or while reception by the remote (receiving) machine was revealed to be
impossible.
impossible.
12
-
Error occurred just after fallback.
13
-
Error occurred after a response to retransmission end command was received.
Code
Final received signal
Error Condition (Receiver side)
0
Incomplete signal frame
Cannot recognize bit stream after flag
1
NSS, DCS
Cannot recognize CFR or FTT signal
Disconnects line during transmission (line error)
Disconnects line during transmission (line error)
2
NSC, DTC
Cannot recognize NSS signal (FIF code etc.)
3
EOP
Cannot recognize MCF, PIP, PIN, RTN, RTP signal
4
EOM
Cannot recognize MCF, PIP, PIN, RTN, RTP signal in the case of mode change
5
MPS
6
PR1-Q
Cannot recognize PIP, PIN signal in the case of TALK request
7
No signal or DCN
No response in transmitter (cannot recognize DIS signal) or DCN signal received* (receiver side)
8
-
Error occurred upon completion of reception of all pages.
9
-
Error occurred when mode was changed or Transmission/Reception switching was performed.
10
-
Error occurred during partial page or physical page reception.
11
-
Error occurred after or during inquiry from the remote (transmitting) machine as to whether recep-
tion is possible or not.
tion is possible or not.
12
-
Error occurred during or just after fallback.
13
-
Error occurred after the retransmission end command was received.
Error Code
Transmission Errors
Reception Errors
E-16
Same as E-0
Same as E-0
E-17
Same as E-1
Same as E-1
E-18
Same as E-2
Same as E-2
E-19
-
Same as E-8
E-20
Same as E-4
Same as E-9
E-21
-
Same as E-10
E-22
-
-
E-23
Same as E-7
Same as E-7
E-24
Same as E-8
-
E-25
Same as E-11
Same as E-11
E-26
Same as E-12
Same as E-12
E-27
Same as E-13
Same as E-13
E-28
-
-
E-29
Error occurred during handshaking for super G3
mode
mode
E-30
E-31
E-31
E-29
Handshaking error in V.8 negotiation procedure
E-30
Handshaking error in V.34 line probing procedure
E-31
Handshaking error in V.34 HDX training procedure
