AL-840 (serv.man7). AL800 840 Service Manual-Simulation codes - Sharp Copying Equipment Service Manual (repair manual). Page 16

Operation/
Procedure

1) The currently set code of the rear void area YES/NO is displayed. 

2) To change the set content, enter the code of your desired setting and press the start button.

Set code

Rear edge void area

0

YES

1

NO

The rear edge void amount can be adjusted with SIM 50-1.
Be sure to set to "0" (Rear edge void area YES).

Note

26 - 30

Purpose

Setting

Function
(Purpose)

Used to set the CE mark conforming operation mode. (For prevention against flicker when driving the fusing
heater lamp)

Section

Fixing (Fusing)

Item

Specifications

Operation mode (Common)

Operation/
Procedure

1) The currently set code of the CD mark conformity (Flicker prevention) is displayed.

2) To change the set content, enter the code of your desired setting and press the start button. The set content

is stored.

Set code

CE mark conformity operation (Flicker prevention)

0

YES

1

NO

When the power of this machine is turned on, if any lamp flickers during printing, set this setting to "1" (YES). Then the
phenomenon may be prevented or reduced. 

Note

26 - 38

Purpose

Setting

Function
(Purpose)

Used to set the photoconductor drum operation inhibit YES/NO when the life is reached.

Section

Item

Specifications

Operation mode (Common)

Operation/
Procedure

1) The currently set code of the machine operation at photoconductor drum life is displayed. 

2) To change the set content, enter the code of your desired setting and press the start button.

Set code

Machine operation at photoconductor life

0

Operation stop

1

Operation allowed

When this is set to "1," the copy/print operation can be performed even if the photoconductor drum reaches its life (20K).
At that time, the copy/print operation can be performed regardless of the photoconductor drum counter value. 
When set to "0," if the photoconductor drum counter reaches the life (20K), the copy/print operation cannot be performed. 
If the photoconductor drum counter reaches the life (20K) during continuous copy/print operation, the machine completes
its job before disabling the operation.

Note

26 - 40

Purpose

Setting

Function
(Purpose)

Used to set the scanner (writing) motor OFF timing.

Section

Laser (Exposure)

Item

Specifications

Operation mode (Common)

8 – 16