CD-DP2500 (serv.man3). Part 2 - Sharp Audio User Guide / Operation Manual. Page 10

In the following cases, the EON stand-by mode will be can-
celled.

●

When the unit is set in the stand-by mode

●

When the unit is switched to another band in the EON stand-
by mode

●

When you change the FM station whilst in the EON stand-
by mode

●

When a preset call is made

●

During the same programme as the specified PTY (or TA) is
being broadcast on the station you are receiving, the unit
will not switch to other network station.

●

If there are more than two other network stations you want
to listen to, compare the strength of each station’s signal
and tune in the station with the strongest signal. (EON-AF)
However, if the frequency of other network station has been
stored in the preset channel memory, the unit will switch to
that preset channel.

●

If you want to cancel the reception of an ON (other network)
station which was tuned in by the EON system and return to
the original station you were receiving, press the EON but-
ton.

●

After the unit returns to the original station, the stand-by
mode will still be active. (The “TI” or “PTY” will remain lit.)

●

The unit will not switch from the ON station to another net-
work station. The unit returns to the original station.

●

When the unit switches automatically to “other network” sta-
tion, if there is any problem with this station or the station
cannot be received properly “WEAK SIG” will appear and
the unit will return to the original station.

●

Even if the unit switches from the station you are listening to
directly to some “other network” station, if the signals from
the other network stations are very weak, the unit will search
for the station with the strongest signal and switch to it.
However, if the signals from all the other network stations
are very weak, or if the tuning conditions are very bad (due
to electrical noise), the unit will stop searching, “WEAK SIG”
will be displayed, and the unit will return to the original sta-
tion you were receiving.

■

Press the ON/STAND-BY button to turn the power on.

Press the TAPE (1 

V

 2) button.

Open the cassette door by pushing the area marked “PUSH
EJECT”.

Load the cassette into the TAPE 1 or TAPE 2 cassette com-
partment.

With cassettes in both decks, press the TAPE (1 

V

 2) button

to switch operation from one deck to the other.

Press the 

0

/

R

 button to start playback.

●

When playback is performed using the remote control,
press the TAPE 1 or TAPE 2 

0

 button.

Press the 

■

 (TAPE 

■

) button.

 1 Press the 

■

 (TAPE 

■

) button, then press the TAPE (1 

V

 2)

button to select TAPE 2.

 2 To advance the tape, press the 

2

 button.

To rewind it, press the 

3

 button.

●

To remove the cassette tape, press the 

■

 (TAPE 

■

) button,

and then open the cassette compartment.

●

Before changing from one tape operation to another, press
the 

■

 (TAPE 

■

) button.

●

If a power failure occurs during tape operation, the tape head
will remain engaged with the tape and the cassette door will
not open. In this case, wait until power is restored.