Read Sharp CD-DP2500 (serv.man3) User Guide / Operation Manual online
31
(Continued)
USING EXTERNAL UNITS
■
Sleep operation
The radio, compact disc and cassette deck can all be turned
off automatically.
off automatically.
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until “SLEEP”
is displayed.
To change the sleep time:
Whilst the sleep time is displayed, press the TUNING/TIME
(
(
X
or
W
) button to adjust the time.
(Maximum: 3 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during the
sleep operation.
The amount of sleep time can also be changed during the
sleep operation.
●
3 hours - 5 minutes
→
5-minute intervals
●
5 minutes - 1 minute
→
1-minute intervals
3
Press the MEMORY/SET button.
4
The unit will enter the stand-by mode automatically after
the preset sleep time has elapsed.
Note:
●
Once the sleep time is set, it will remain the same duration
until the setting is changed.
until the setting is changed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by mode.
■
Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
through this unit:
1
Use a separately available RCA lead to connect the desired
external unit to the VIDEO/AUX 1 or 2 sockets.
(red
external unit to the VIDEO/AUX 1 or 2 sockets.
(red
→
right channel, white
→
left channel)
●
When using video equipment (Laser Disc player or VCR),
be sure to connect the audio output to this unit and the
video output to a television.
be sure to connect the audio output to this unit and the
video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the VIDEO/AUX (1
V
2) button.
●
Select either “VIDEO 1” or “VIDEO 2”.
4
Operate the external unit.
5
To record the sound from the external unit, perform steps 2 - 4
of the “Recording from the built-in radio” section on page 29.
of the “Recording from the built-in radio” section on page 29.
Note:
●
To prevent hum interference, do not place this unit near tele-
vision receivers.
vision receivers.
■
CD digital output (optical)
The CD digital signal from this unit can be recorded
by other DAT or MiniDisc recorders.
by other DAT or MiniDisc recorders.
1
Remove the CD DIGITAL OUT socket cover.
2
Use a commercially available digital cable to connect the unit
to the OPTICAL IN socket of a MiniDisc recorder or a DAT.
3
Put the external unit in the recording mode.
4
Play a CD on this unit.
Note:
●
Only CD signals can be output.
(Main unit operation)
RCA
lead
lead
To the line
output socket
output socket
Commercially
available digital
cable
available digital
cable
Click on the first or last page to see other CD-DP2500 (serv.man3) service manuals if exist.