Read Harman Kardon SB 16 (serv.man9) EMC - CB Certificate online
Clause
Requirement - Test
Result - Remark
Verdict
TÜV SÜD Product Service GmbH
Report reference No.:081-61102-000
Electrical Safety
F10Y2-X dev.DOC
Ridlerstr. 65
2006-11-02
D-80339 München
Page 7 of 52
Test Report National land Group Differences IEC 60065 7
th
Ed. Rev. 00 / 2006-02
Clause of AS/NZS 4695.2.2
Change
5 Severities
Replace with:
The duration of application of the test flame shall be 30 s ±1 s.
8 Test procedure
8.2
Replace the first sentence with:
The specimen shall be arranged so that the flame can be applied to a vertical
or horizontal edge as shown in the examples of figure 1.
The first paragraph does not apply.
8.4 Addition:
If possible, the flame shall be applied at least 10 mm from a corner.
Replace the first sentence with:
The specimen shall be arranged so that the flame can be applied to a vertical
or horizontal edge as shown in the examples of figure 1.
The first paragraph does not apply.
8.4 Addition:
If possible, the flame shall be applied at least 10 mm from a corner.
8.5
Replace with:
The test shall be made on one specimen. If the specimen does not withstand
the test, the test may be repeated on two further specimens, both of which shall
then withstand the test
the test, the test may be repeated on two further specimens, both of which shall
then withstand the test
Clause of AS/NZS 4695.2.2
Change
10 Evaluation of test results
Replace with:
The duration of burning (tb) shall not exceed 30 s. However, for printed circuit
boards, it shall not exceed 15 s.
boards, it shall not exceed 15 s.
N
The needle-flame test shall not be carried out on parts of material classified as V-
0 or V-1 according to AS/NZS 60695.11.10 provided that the sample tested was
not thicker than the relevant part.
0 or V-1 according to AS/NZS 60695.11.10 provided that the sample tested was
not thicker than the relevant part.
20.201.2.3Testing by needle-flame test
If parts, other than enclosures, do not withstand the glow wire tests of 20.201.2.2,
by failure to extinguish within 30 s after the removal of the glow-wire tip, the
needle-flame test detailed in 20.201.2.2 shall be made on all parts of non-metallic
material which are within a distance of 50 mm or which are likely to be impinged
upon by flame during the tests of 20.201.2.2. Parts shielded by a separate barrier
which meets the needle-flame test shall not be tested.
by failure to extinguish within 30 s after the removal of the glow-wire tip, the
needle-flame test detailed in 20.201.2.2 shall be made on all parts of non-metallic
material which are within a distance of 50 mm or which are likely to be impinged
upon by flame during the tests of 20.201.2.2. Parts shielded by a separate barrier
which meets the needle-flame test shall not be tested.
N
Click on the first or last page to see other SB 16 (serv.man9) service manuals if exist.