Read Sony SAL70300G2 Service Manual online
2-5
SAL70300G2 (4.5-5.6/70-300 G SSM II) (70-300mm F4.5-5.6 G SSM II)
HELP06
1. Install the pressurizing plate, facing its convex side to the fine same side.
2. Install the SSM wave washer, facing its concave side down and its convex side up.
2. Install the SSM wave washer, facing its concave side down and its convex side up.
Note:
When installing the SSM wave washer, be careful for valley part not to overlap the flexible board of stator.
Convex Side
Cross
Section
Section
Convex Side
Concave Side
Cross
Section
Section
Valley part
Valley part
Flexible
board
of stator
board
of stator
Fine Same
SSM Wave Washer
Pressurizing
Plate
Plate
SSM Wave Washer
3. Align three locations of groove A of SSM Retainer Plate with three locations of Bayonet screw, and put it on the SSM Wave Washer.
4. Hold down the SSM Retainer Plate in the direction of the arrow A.
5. Rotate the SSM Retainer Plate in the direction of the arrow B so that three locations of groove B become the position of three locations
4. Hold down the SSM Retainer Plate in the direction of the arrow A.
5. Rotate the SSM Retainer Plate in the direction of the arrow B so that three locations of groove B become the position of three locations
of Bayonet screw.
Groove A
Groove B
Groove A
A
B
Groove A
Bayonet screw
SSM Wave Washer
Bayonet screw
Bayonet screw
Groove B
Groove B
SSM Retainer Plate
Groove B
SSM Retainer Plate
HELP07
1. Install the rotor (stator set) and then the three pieces of stopper.
Note 1:
Never touch the resin surface (black coated surface).
If you touch it, wipe the resin surface (black coated surface) with paper towel soaked with ethanol.
Note 2:
Due to grease of finger, the function of rotor (stator set) will deteriorate, leading to a trouble. To avoid this, wear the finger sack.
Note 3:
Attach stopper to the center hole as shown in the figure.
Resin Surface
(Black Coated Surface)
(Black Coated Surface)
Rotor (Stator Set)
Never touch the resin surface
Rotor (Stator Set)
Stoppers
Stopper
2. Align the flexible board of stator (stator set) and the flexible board of Z.ECD flexible board at the positions shown in the figure.
3. Aligning the stopper with the groove of stator (stator set), install the stator (stator set).
3. Aligning the stopper with the groove of stator (stator set), install the stator (stator set).
Note:
Due to grease of finger, the function of stator (Stator Set) will deteriorate, leading to a trouble. To avoid this, wear the finger sack.
Stator (Stator Set)
Never touch the slip surface
Sliding surface of the stator with
the rotor (Stator Set)
the rotor (Stator Set)
Flexible Board
(Z.ECD Flexible Board)
(Z.ECD Flexible Board)
Flexible Board
Stator (Stator Set)
Stoppers
Stopper
Click on the first or last page to see other SAL70300G2 service manuals if exist.