SAL70300G2 - Sony Digital Camera Service Manual (repair manual). Page 7

2-4

SAL70300G2 (4.5-5.6/70-300 G SSM II) (70-300mm F4.5-5.6 G SSM II)

6.  Set the unit to the TELE end.
7.  Aligning the function lever with the screw holes of preset ring assy, push the function lever to the preset ring assy.
8.  Fix it with two screws.

  Be careful for function lever not to come off the aperture operation pin.

9.  Apply the adhesive bond (B-10) to heads of screws (two locations).

 

Function Lever

Aperture Operation Pin

Preset Ring Assy

Push the function lever
to the preset ring assy

Set the unit to
TELE end.

Apply the adhesive
bond (B-10)

10. Hook the main spring guide side of main spring.

 

Main Spring

Main Spring Guide

Main Spring

 

Adhesive bond (B-10): 

J-6082-612-A

1.  Align the index mark (focus) and index mark (zoom) as shown in the figure and install the rear light shield barrel assy.
2.  Tighten four screws and apply the adhesive bond (B-10) to the heads of screws (four locations).

 

Rear Light Shield
Barrel Assy

Model No. Label

Apply the adhesive
bond (B-10)

Index Mark (Focus)

Index Mark (Zoom)

1.  When installing the fixed barrel assy to the unit, install the fixed barrel assy while drawing the flexible board of stator out of the hole.
2.  Make a folding wrinkle of flexible board of stator as shown in the figure.

 

Valley 
Hold

Valley 
Hold

Valley Hold

Fixed Barrel Assy

Flexible board
of stator

Flexible board
of stator

Hole