Read Sony SAL70300G2 Service Manual online
2-9
SAL70300G2 (4.5-5.6/70-300 G SSM II) (70-300mm F4.5-5.6 G SSM II)
HELP14
Adhesive bond (B-10):
J-6082-612-A
1. Align the index mark of outer barrel assy with 70 of scale on the zoom ring assy.
Index Mark
70
2. Insert the tip of zoom linkage plate in the zoom ring linkage groove and fix it with two screws.
3. Apply the adhesive bond (B-10) to the heads of screws (two locations).
3. Apply the adhesive bond (B-10) to the heads of screws (two locations).
Zoom Linkage Plate
Zoom Linkage Plate
Zoom Ring Linkage Groove
Zoom Ring Linkage Groove
Apply the adhesive
bond (B-10)
bond (B-10)
4. Set the 2nd-F linkage pin to the middle range (near-infinity) and to the TELE end. Then, confirm zoom action.
2nd-F Linkage Pin
(near position)
(near position)
Move the unit to the TELE
end, confirm zoom action.
end, confirm zoom action.
HELP15
1. Set the unit to the WIDE end.
2. Aligning the FHB flexible board with the Z.ECD flexible board, install the outer barrel assy, zoom ring assy and zoom rubber to the
2. Aligning the FHB flexible board with the Z.ECD flexible board, install the outer barrel assy, zoom ring assy and zoom rubber to the
length groove barrel assy.
3. Fix them with three MF springs and screws.
Note:
Install the MF spring so that its spring comes outside.
Outer Barrel Assy,
Zoom Ring Assy,
Zoom Rubber
Zoom Ring Assy,
Zoom Rubber
FHB Flexible Board
Z.ECD Flexible
Board
Board
MF Spring
Spring
(MF Spring)
(MF Spring)
Set the unit to
WIDE end.
WIDE end.
4. Align the FHB flexible board and Z.ECD flexible board with the positioning index boss overlaying them and solder them at two loca-
tions, as shown in the figure below.
5. Fix the FHB flexible board with one screw.
Solder
FHB Flexible Board
FHB Flexible Board
Z.ECD Flexible Board
Z.ECD Flexible Board
Positioning Index Boss
Click on the first or last page to see other SAL70300G2 service manuals if exist.