Read Sony SAL300F28G Service Manual online
HELP
SAL300F28G (2.8/300 G) (300mm F2.8 G)
HELP32
Adhesive bond (B-10):
J-6082-612-A
1.
Install the A encoder brush to the focus connect ring A with two screws tentatively.
2.
After performing the [5-6. Focus Brush Position Adjustment], apply the adhesive bond (B-10) to the indicated portions.
HELP33
Adhesive bond (B-40): J-6082-614-A
Adhesive bond (LOCTITE 460)
Note:
Use the adhesive bond (LOCTITE 460) or the equivalent.
Do not use the instant glue which becomes white after dried.
1.
Affix the focus connection ring tape to the focus cam ring as shown in the figure below.
2.
Make two pairs of focus connect ring pin and focus insulate bush and apply two drops of adhesive bond (B-40) to the tips of focus
connect ring pins. Fix the focus connect ring A to the focus cam ring tentatively to the extent that the gap exists.
3.
Fill the adhesive bond (LOCTITE 460) in the gap between focus cam ring and focus connect ring A.
4.
Tighten firmly two focus connect ring pins.
Apply the adhesive bond (B-10)
A Encoder Brush
Focus Connection
Ring A
Ring A
Focus Cam Ring
Affix the focus connection ring tape,
aligning the hole of focus connection
ring tape with the hole of focus cam ring.
aligning the hole of focus connection
ring tape with the hole of focus cam ring.
Focus Cam Ring
Focus Conection Ring Tape
Focus Conection Ring Tape
Tighten the focus connect ring pin tentatively
and fill the adhesive bond (LOCTITE 460)
in the gap.
and fill the adhesive bond (LOCTITE 460)
in the gap.
Focus Conection
Ring Tape
Ring Tape
Focus Connect
Ring A
Ring A
Focus Connect
Ring A
Ring A
Focus Connect Ring
Pin
Pin
Focus Connect Ring
Pin
Pin
Focus Insulate Bush
Focus Insulate Bush
Holes
Apply the adhesive bond (B-40)
Click on the first or last page to see other SAL300F28G service manuals if exist.