Read Sony XDR-S60DBP Service Manual online
XDR-S60DBP
5
2-5. CABINET (REAR) BLOCK
4 tapping screw
(BV
B2.6)
4 two tapping screws
(BV
B2.6)
2 tapping screw
(P
B2.6)
4 four tapping screws
(BV
B2.6)
1 battery case lid block
A
7 cabinet (rear) block
3 lid (connector)
6 connector
(CN402)
5
Remove the cabinet rear block
in the direction of an arrow.
–
Rear view
–
Note 1: When installing the cabinet
(rear) block, arrange wire in
the direction of the arrow
A.
The wire cannot be seen.
The wire can be seen.
OK
NG
–
Rear view
–
–
Rear view
–
Note 2: When installing the cabinet (rear) block, arrange wire in
check that the wire is not visible from the hole for the connector.
–
Cabinet (rear) block front bottom view
–
Wire setting
2 tape
(sub
material)
tape (sub material)
3 Remove the solder.
[red]
7 Remove the solder.
[red]
5 JACK HOLD board
8 Remove the bond.
9 wire fuse
(F102)
wire fuse (F102)
JACK board
1 Remove the solder.
[black]
6 Remove the JACK board block
in the direction of an arrow.
Note: When installing the wire fuse (F102), the guidance
of fuse must not be hidden by a tape (sub material).
4 tapping screw
(PWH
B2.6)
The wire [black] is upper.
The wire [blue/white/red] is under.
2-6. WIRE FUSE (F102)
Click on the first or last page to see other XDR-S60DBP service manuals if exist.