Read Sharp MX-LCX5 Service Manual online
MX-LCX5 REPLACEMENT AND ADJUSTMENT 3 – 1
MX-LCX5
Service Manual
[3] REPLACEMENT AND
ADJUSTMENT
1. Removing trays
CAUTION:
• Tray 5 weighs 27 kg (60 lb.) empty. Trays 4 and 6 weigh 20 kg
• Tray 5 weighs 27 kg (60 lb.) empty. Trays 4 and 6 weigh 20 kg
(44 lb.) each empty.
• To prevent damage to the tray and personal injury, never attempt
to lift a tray alone or without attaching the carrying handles, espe-
cially if a tray is loaded with paper.
cially if a tray is loaded with paper.
• Two people on each side of the tray should lift the carrying han-
dles together to lift and move the tray.
• Never remove the tray if the LCT has not been docked to the
copier. Removing the tray while the LCT is standing alone can
unbalance the LCT and cause it to fall over.
unbalance the LCT and cause it to fall over.
Important:
Only one set of carrying handles is attached to the side of Tray 5.
Follow the procedure below to attach and use these handles to
move Tray 4, 5, or 6.
Only one set of carrying handles is attached to the side of Tray 5.
Follow the procedure below to attach and use these handles to
move Tray 4, 5, or 6.
1)
Pull the tray [A] out of the LCT until it stops.
2)
Remove the screws from the right rail [B] (screw x 3)
3)
Remove the screws from the left rail [D] (screw x 3)
NOTE: You do not need to remove the screw for the stopper
pin bracket at the back of the left rail.
NOTE: You do not need to remove the screw for the stopper
pin bracket at the back of the left rail.
4)
Remove carrying handles [A] and [B] from the right side of the
tray (screw x 2 ea.)
tray (screw x 2 ea.)
5)
Use the same screws to attach the carrying handles at (1) and
(2).
(2).
6)
With one person on each side of the tray, lift it carefully and
remove it from the rails.
remove it from the rails.
2. Front door and covers
Important:
• The frame is held together by 8 blue screws.
• To avoid weakening or warping the shape of the frame, never
• The frame is held together by 8 blue screws.
• To avoid weakening or warping the shape of the frame, never
remove these blue screws.
NOTE: The upper inner cover must be removed before the top
cover.
Remove:
[A] Right cover (screw x 6)
[B] Right rear cover (screw x 6)
[C] Left rear cover (screw x 6)
[D] Top cover (screw x 5)
[E] Front door (stopper x 1)
[A] Right cover (screw x 6)
[B] Right rear cover (screw x 6)
[C] Left rear cover (screw x 6)
[D] Top cover (screw x 5)
[E] Front door (stopper x 1)
NOTE: While lifting the top cover, remove the snap ring and front
door.
[F] Paper slot cover (screw x 2)
[A]
[B]
(1)
(2)
[C]
[E]
[B]
[F]
[D]
[A]
Click on the first or last page to see other MX-LCX5 service manuals if exist.