MX-LCX5. Service Manual - 01.05.08 - Sharp Copying Equipment Service Manual (repair manual). Page 10

MX-LCX5  REPLACEMENT AND ADJUSTMENT  3 – 6

Normally the side registration of the image can be adjusted in the
SP mode.
If the punch hole positions are not aligned from a particular feed
station, however, you can manually adjust the side registration by
changing the tray cover position for that tray, and then adjust the
side registration of the image.
1)

Pull out the tray.

2)

Change the screw positions [A] at both the right and left sides
as shown.

NOTE: Adjustment range: 0 

± 2.0 mm adjustment step: 1.0 mm/

step

Image Position Sensor
• Disconnect the LCT from the copier.
[A] Image position sensor unit (screw x 2, connector x 1)
[B] Stopper (screw x 1)
[C] Image position sensor
• After replacing the image position sensor do the procedure for

image position sensor adjustment. (see 12.)

Image Position Sensor Board
• Disconnect the LCT from the copier.
[D] Cover (screw x 2, clamp x 2)
[E] Image position sensor board (screw x 2, connector x 2, clamp x
2)

1)

Remove the lower-stage cassette. (6 screws)

2)

Remove the rear cabinet. (6 screws)

[A]

[B]

[C]

[E]

[D]

Interface harness

(with heater line)

M4 washer screw

(x 1)

M4 screw (x 7)

Heater cover

Clamp (x 2)

Heater

(x 2)