Read Sharp MX-LCX4 Service Manual online
MX-LCX4 REPLACEMENT AND ADJUSTMENT 3 – 5
8. Side registration adjustment
Normally the side registration of the image can be adjusted in the
SP mode.
If the punch hole positions are not aligned from a particular feed
station, however, you can manually adjust the side registration by
changing the tray cover position for that tray, and then adjust the
side registration of the image.
1)
SP mode.
If the punch hole positions are not aligned from a particular feed
station, however, you can manually adjust the side registration by
changing the tray cover position for that tray, and then adjust the
side registration of the image.
1)
Pull out the tray.
2)
Change the screw positions [A] at both the right and left sides
as shown.
as shown.
NOTE: Adjustment range: 0
± 2.0 mm adjustment step: 1.0 mm/
step
9. Dehumidifier heater installing
procedures (0PQC4150431//)
A. Component parts
B. Installing procedures
1)
Remove the lower-stage cassette (4 screws).
2)
Remove the rear cabinet. (5 screws)
Remove the earth plate. (2 screws)
[A]
Heater cover
Interface harness
(with heater line)
Heater
(x 2)
M4 screw (x 7)
M4 washer screw (x 1)
Click on the first or last page to see other MX-LCX4 service manuals if exist.