MX-LCX4. Service Manual 01.05.08 - Sharp Copying Equipment Service Manual (repair manual). Page 8

MX-LCX4  REPLACEMENT AND ADJUSTMENT  3 – 4

Remove:
• Rear cover. (see 1.)
[A] Main control board bracket (screw x 5, connector x All)
[B] 4th lift motor (screw x 3, connector x 1)
[C] 5th lift motor (screw x 3, connector x 1)

Disconnect the LCT from the copier.
[A] Harness cover (screw x 1, clamp x 1)
[B] Image position sensor unit (screw x 1, clamp x 1, connector x 1)
[C] Stopper (screw x 1)
[D] Image position sensor
• After replacing the image position sensor, do the procedure for

image position sensor adjustment. (see 9.)

[E] Image position sensor board (screw x 2, clamp x 1, connector x
2)

[F] Exit sensor unit (screw x 1, connector x 1, clamp x 1)
[G] Exit sensor

Remove:
• Rear cover. (see 1.)
• Right cover. (see 1.)
[A] Paper height sensor unit (clamp x 2, screw x 1, connector x 4).
[B] Paper height sensors (Hooks x 4 each)
[C] Paper size sensors (connector x 1 each)

Remove:
• Rear cover. (see 1.)
[A] Main control board (screw x 6, Standoffs x 2, connector x All)

[A]

[B]

[C]

[A]

[B]

[C]

[D]

[E]

[G]

[F]

[A]

[B]

[A]

[B]

[C]

4th/5th Tray

6th Tray

[A]