Read Sharp MX-LCX3N (serv.man2) Service Manual online
MX-7040N MX-LCX3N (LARGE CAPACITY TRAY) 5 – 9
2)
Push the large capacity tray into the closed (locked) position.
Then make a copy again to check to insure that there is no
shift. Repeat this procedure as required.
shift. Repeat this procedure as required.
b. When shifted to the rear side
When shifting the line of printing from the center of the paper in the
B direction of arrow as shown below:
1)
When shifting the line of printing from the center of the paper in the
B direction of arrow as shown below:
1)
Loosen the blue off-center adjustment screws (each 2 pcs.),
and move the side plate by the dimension shifted in the direc-
tion B (F side), and tighten the blue screws.
and move the side plate by the dimension shifted in the direc-
tion B (F side), and tighten the blue screws.
NOTE: Move the side plates by the same dimension on the
front side and the rear side.
2)
Push the large capacity tray into the closed (locked) position.
Then make a copy again to insure that there is no shift. Repeat
this procedure as required.
this procedure as required.
(3) Regulation plate adjustment
Since the regulation plates are adjusted when shipping, there is
basically no need to readjust. If, however, there is skew, adjust the
regulation plate width and the diagonal feed in the following proce-
dures:
basically no need to readjust. If, however, there is skew, adjust the
regulation plate width and the diagonal feed in the following proce-
dures:
a. Regulation plate width adjustment
1)
1)
Press the lock button on the front cabinet and lower the paper
feed base tray to the paper supply position. Pull out the large
capacity tray.
feed base tray to the paper supply position. Pull out the large
capacity tray.
Click on the first or last page to see other MX-LCX3N (serv.man2) service manuals if exist.