Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man19) Peripheral online
MX-FNX4 DISASSEMBLY AND ASSEMBLY 6 – 54
CAUTION: When removing, be careful not to damage the flag [8].
5) Turn back the stapler, disconnect the connectors [9] at two
positions, and remove the two screws [10]. Then, remove the
stapler from the stapler base.
stapler from the stapler base.
k. Removal of stapling tray
1) Remove the snaps [1] at four positions, and remove the sensor
1) Remove the snaps [1] at four positions, and remove the sensor
flag [3] from the delivery roller [2].
CAUTION: The sensor flag arm is easily broken. When removing it,
hold the base section of the snap holder. When install-
ing, insert the projection of the snap of the sensor flag
into the hole on the stapling tray side.
ing, insert the projection of the snap of the sensor flag
into the hole on the stapling tray side.
2)
Remove the E-ring [4], gear [5], parallel pin [6], E-ring [7], and
the bearing [8] in front of the delivery roller.
the bearing [8] in front of the delivery roller.
CAUTION: When the gear [5] is removed, the parallel pin [6] falls.
Be careful not to lose it.
3)
Disconnect all the connectors [9] of the finisher controller PCB.
4)
Remove the four screws [10] to remove the finisher controller
PCB base [11].
PCB base [11].
5)
Release the pawl [13] of the clutch [12] on the back of the
delivery roller, and remove the clutch [12].
delivery roller, and remove the clutch [12].
6)
Remove the E-ring [14] and the bearing [15], and remove the
delivery roller.
delivery roller.
[8]
[5]
[3]
[4]
[7]
[6]
[10]
[9]
[1]
[3]
[2]
[5] [6]
[7] [8]
[4]
[10]
[11]
[9]
[10]
[13]
[14] [15]
[12]
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man19) service manuals if exist.