Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man19) Peripheral online
MX-FNX4 DISASSEMBLY AND ASSEMBLY 6 – 53
h. Removal of No. 2 tray
CAUTION: Note for installing or moving the tray
When moving down the tray, push up the shutter [1],
and release the latch [2] on the lower surface of the tray
to lower the tray.
When the latch is released, the tray will free-fall. Hold
the tray with your hand during the removal.
and release the latch [2] on the lower surface of the tray
to lower the tray.
When the latch is released, the tray will free-fall. Hold
the tray with your hand during the removal.
1) Remove the screw [1], and remove the stopper [2].
2) Remove the two screws [3], and disconnect the connector [4].
3) Insert your finger into the hole in the back of the No.2 tray [5].
Push the tray lift motor gear [6] toward you to release the
clutch, and lift the No.2 tray [5].
clutch, and lift the No.2 tray [5].
CAUTION: When the clutch of the tray lift motor gear is released, it
falls by its own weight. When releasing the clutch, there-
fore, hold the tray at the bottom in advance. When
installing it, take care not to twist the tray cable.
fore, hold the tray at the bottom in advance. When
installing it, take care not to twist the tray cable.
i. Removal of grate-shaped lower guide
1)
1)
Remove the ten screws [1], and remove the grate-shaped
lower guide [2].
lower guide [2].
CAUTION: When installing, be careful not to damage the grate-
shaped lower guide by hanging it to the sensor flag arm
on the delivery side.
on the delivery side.
j. Removal of stapler
1)
1)
Pull out the stapler, remove the screw [1], and remove the PCB
cover [2].
cover [2].
2)
Release the pawl [3], and remove the PCB [4].
3)
Disconnect the connectors [5] at three positions.
4)
Remove the screw [6], and remove the stapler with the stapler
base [7].
base [7].
[2]
[1]
[2]
[1]
[4]
[3]
[3]
[5]
[6]
[1]
[1]
[1]
[2]
[2]
[1]
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man19) service manuals if exist.