AR-PB9 (serv.man2). ARPB9-Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 7

3) Turn on your computer and start Windows.

Note: Before installing the printer driver, be sure to close all

other applications which may be open.

4) When using Windows 95 on a personal computer with plug &

play*, the “Update Device Driver Wizard” window will appear. In-
sert the installation CD-ROM into the CD-ROM drive. Click the
Next button and follow the on-screen instructions. If the “Copy-
ing Files” window appears during this operation, enter R:\ (if the
CD-ROM is designated as drive R), click the OK button and fol-
low the on-screen instructions.

● If you use Windows 95 and the “New Hardware Found” window will

appear, select Driver from Disk Provided by Hardware Manufacturer
and then click the OK button. Proceed to step 6.

● If you use Windows 95 and the screen shown above or the “New

Hardware Found” window does not appear, proceed to step 5.

● If you use Windows NT 4.0, proceed to step 5.
* Plug & play
This feature is effective if both the computer and peripheral equipment
are equipped with IEEE 1284 compliant parallel interface.

Note: The screen displayed depends on the version of Win-

dows you are using.

5) Insert the installation CD-ROM into the CD-ROM drive.

Click the Start button and select Run. When the screen shown
below appears, type R:\SETUP (if the CD-ROM is designated
as drive R) and click the OK button. Follow the on-screen in-
structions.

6) The  “Install From Disk” window will appear. Insert the installa-

tion CD-ROM into the CD-ROM drive. Type R:\ (if the CD-ROM
is designated as drive R) and click the OK button. Follow the
on-screen instructions.

Note: If you have any problem with the test print, check the

symptoms and solutions. Print the test page again after
resolving the problem.

With both the computer and the printer turned off, connect the printer
to the computer with either a parallel or a USB interface cable.
1) Load paper into the paper tray of the printer. For instructions

on loading paper, see the section LOADING COPY PAPER
found in the copier operation manual.

2) Turn on the printer.
3) Turn on your computer and start Windows.
When using the USB interface:
● Connect your personal computer and the printer using a USB inter-

face cable if you have not already done so. (For information about
connecting the USB interface cable)

● When the “Add New Hardware Wizard” window appears, insert the

installation CD-ROM, click the Next button, follow the on-screen in-
structions, and finally click the Finish button.

Note: Before installing the printer driver, be sure to close all

other applications which may be open.

4) When using Windows 98 on a personal computer with plug &

play*, the “Add New Hardware Wizard” window will appear.
Click the Next button and follow the on-screen instructions.

● If the “Add New Hardware Wizard” window does not appear, proceed

to step 8.

5) Select Search for the best driver for your device and click the

Next button.

6) Insert the installation CD-ROM into the CD-ROM drive. (If you

are using the USB interface, confirm that the installation CD-
ROM is in the CD-ROM drive.) Select the CD-ROM drive and
click the Next button.

AR-PB9

3  –  4