AR-F13 (serv.man2). AR-F13 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 12

AR-F13  UNPACKING AND INSTALLATION  3-7

6) Attach the punch module.

<1> Insert the two bosses of the punch unit into the boss holes of

the finisher and fix the punch module using three screws.

Note: For the screws, use a supplied screw and the two screws

that have been removed in step 4).

7) Connect the harness of the punch module to the PWB of the fin-

isher.

Remove the clamps that fix the harness, handle the wiring of har-
ness A (purple) and harness B (orange), and fix them with the
clamps.

8) Reattach the covers that have been removed.

<1> Hang the two pawls of the top cover and secure them using

the two screws.

<2> Pass the relay harness to the rear cabinet and secure the

rear cabinet using the three screws.

<3> Remove the lock release lever that has been attached to the

front cabinet.
Reattach the front cabinet to its original position, push in the
staple unit, and attach it using the two screws.
Insert the protrusion (B) of the lock release lever that has
been removed before to the hole (C) of the latch arm.
After attaching it, move the lever to check that it moves
smoothly.
If the lever does not move smoothly, remove the lock release
lever by releasing the pawl at the lower part of the lock
release lever using a flat-blade screwdriver or the like and
then insert it again.

Boss

Boss hole

Boss

Boss hole

Screw (with rosette)
(supplied with this unit)

Screw

Screw

Punch module

Clamps

Clamps

Harness A (purple)

Harness B (orange)

Harness A (purple)

Harness B (orange)

Screw

Screw

Top cover

Pawl

Screw

Relay harness

Opening for
relay harness

Screws

Rear cabinet

Staple unit

Screws

Front cabinet

Lock release 
lever (A)

Projection (B)

Latch arm

Pawl (D)