AR-F13 (serv.man2). AR-F13 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 9

AR-F13  UNPACKING AND INSTALLATION  3-4

<6> Reattach the removed cover so that the four securing bosses

of the cover are inserted into the four positioning holes and
then tighten the four screws in the order of <1> and <2>
shown in the illustration to secure the cover.

10) Connect the connector of the saddle finisher.

<1> Remove the screw that secures the power supply cover at

the rear face of the stand and remove the power supply
cover.

<2> Cut out the portion of the power supply cover shown in the

illustration.

<3> Secure the power supply cover to the rear cabinet.

<4> Connect the connector for connecting the saddle finisher to

the connector on the stand and secure it with the screw on
the connector.

If another peripheral device must be installed, carry out the following
steps at the end of the installation work.

11) Move the staple unit of the saddle finisher to

      the cartridge insertion position.

<1> Insert the power plug of the main unit to the outlet and turn

on the main switch.

<2> Wait for some time until the initial operation of the saddle fin-

isher is complete.

12) Set the staple cartridge to the staple unit.

<1> Open the front cover of the saddle finisher and pull out the

staple unit.

<2> Push the staple cartridge securely into the staple section until

it clicks.

13) Attach the staple unit to the finisher.

Insert the staple section and close the front cover of the finisher.

14) Paste the staple position label.

Open the front cover and paste staple position label A to the posi-
tion shown in the illustration.

If the B/W scanner module/DSPF is attached, paste staple position
label B to the position on the B/W scanner module/DSPF shown in
the illustration.

Cover

Screw

Screw

Screw

Screw

Power supply cover

Screw

Cut-out portion

Connector

Screw

Check that the right 
and left of the staple 
cartridge are not 
loose.

Y

X

For Scanner

For RADF

X

Y