Read Sharp AR-F13 (serv.man2) Service Manual online
AR-F13 UNPACKING AND INSTALLATION 3-5
2. AR-PN1
<Before installation>
For installation of AR-PN1A/PN1B/PN1C/PN1D, a saddle stitch
finisher (AR-FN13) must have been installed.
1) Turn off the main switch of the main unit of the printer.
<1> Turn the main switch located on the front side of the main
unit to the "OFF" position.
<2> Then remove the power plug of the main unit from the outlet.
<3> Loosen the screw and remove the connector of the finisher.
2) Remove the front cover from the right front of the finisher.
Remove the screws A and B (two for each) that secure the finisher
front cover and remove the front cover.
front cover and remove the front cover.
3) Remove the front cabinet and the rear cabinet from the finisher.
<1> Open the front door of the finisher and remove the jam han-
dling dial.
<2> Remove the four front cabinet securing screws, pull out the
staple unit until it stops, then remove the pawl of the front
cabinet in the direction indicated by the arrow and remove
the front cabinet.
cabinet in the direction indicated by the arrow and remove
the front cabinet.
<3> Remove the three rear cabinet securing screws, remove the
pawl in the direction indicated by the arrow, and remove the
rear cabinet.
At this time, remove the relay harness through the opening of
the rear cabinet.
rear cabinet.
At this time, remove the relay harness through the opening of
the rear cabinet.
Parts included
Screw
(M4 x 6 with rosette)
: 1 pc.
Harness A (purple): 1 pc.
Harness B (orange): 1 pc.
Dust box label:
1 sheet
Hole punch position label*:
2 sheets
* Will not be used.
Use the hole punch
position labels packed
in AR-F13.
position labels packed
in AR-F13.
Connector
Screw
Screws B
Screws A
Front cover
Jam handling dial
Staple unit
Pawl
Screws
Screws
Front cabinet
Screw
Relay harness
Opening for
relay harness
relay harness
Screw
Rear
cabinet
cabinet
Pawl
Click on the first or last page to see other AR-F13 (serv.man2) service manuals if exist.