Read Sharp AR-F13 (serv.man2) Service Manual online
AR-F13 UNPACKING AND INSTALLATION 3-3
8) Connect the saddle finisher to the main unit.
<1> Move the saddle finisher toward the left (exit area) of the main
unit.
<2> Position the connecting plate that has been attached to the
saddle finisher to the two holes at the lower left of the
optional stand, and secure it with two screws C.
optional stand, and secure it with two screws C.
At this time, attach the rear screw to the hole with marking C.
9) Adjust the height of the saddle finisher.
<1> Move the saddle finisher close to the main unit.
<2> Ensure that the guide pin of the lock plate that has been
attached to the duplex bypass/inverter unit is inserted
smoothly into the connecting hole of the saddle finisher.
smoothly into the connecting hole of the saddle finisher.
∗
If the guide pin should not inserted smoothly, adjust it using the pro-
cedure described below.
cedure described below.
A. If the connecting hole of the saddle finisher is deviated from the
guide pin of the lock plate:
<1> Loosen the two adjusting part securing screws at the rear of
saddle finisher stand section.
<2> Turn the rear height adjusting handle so that the height of the
guide pin matches with the height of the center of the con-
necting hole.
necting hole.
<3> Loosen the two adjusting part securing screws at the front of
the saddle finisher stand section.
<4> Turn the front height adjusting handle so that the height of
the top of the rib on the front cover matches with the height of
the top of the stand.
the top of the stand.
<5> Tighten the adjusting part securing screws (two for each of
front and rear).
<6> Carry out work B. (next page)
B: If the connecting hole of the saddle finisher matches with the guide
pin of the lock plate:
<1> Push the saddle finisher toward the main unit.
<2> Check the clearance between the saddle finisher and the
main unit at the upper and lower parts.
• If clearance A is not equal to clearance B:
<1> Remove the four screws that secure the cover of the saddle
finisher stand and remove the cover.
<2> Loosen the adjusting part securing screws (two for each of
front and rear).
<3> Turn the height adjusting screws (one for each of front and
rear) respectively so that clearance A becomes equal to
clearance B.
clearance B.
<4> Check that clearance A and clearance B are uniform both at
the front and at the rear.
<5> Tighten the adjusting part securing screws (two for each of
front and rear).
Screws C
Connecting plate
Optional stand
C
Guide pin
Adjusting
hole
hole
Height adjusting handles
Adjusting part securing screws
Adjusting
part securing
screws
part securing
screws
Front side
Rear side
Continued to the next page
Main unit
Stand
Front cover
Rib
Clearance A
Clearance B
Cover
Screw
Screw
Screw
Screw
Adjusting part
securing screws
securing screws
Adjusting part
securing screws
securing screws
Front side
Rear side
Height adjusting
screws
screws
Click on the first or last page to see other AR-F13 (serv.man2) service manuals if exist.