Read Panasonic SB-PTX50EG / SB-HF100P Service Manual online
For SB-HF100
Type
Type
2 way, 3 speaker system (Bass reflex)
Speaker unit(s)
Impedance 6
Ω
1. Woofer
6.5 cm Cone type x 2
2. Tweeter
6 cm Cone type
Input power (IEC)
250 W (Max)*
Output sound pressure
83 dB/W (1.0 m)
Frequency range
80 Hz to 25 kHz (-16 dB)
93 Hz to 22 kHz (-10 dB)
SB-PTX50EG
SB-HF100P
Colour
(K)... Black Type (For SB-PTX50EG)
(K1)... Black Type (For SB-HF100P)
(K)... Black Type (For SB-PTX50EG)
(K1)... Black Type (For SB-HF100P)
Dimensions (W x H x D)
121 mm x 328 mm x 129 mm
Mass (Weight)
1.7 kg
Notes:
1. Specifications are subject to change without notice. Mass and
dimensions are approximate.
1. Specifications are subject to change without notice. Mass and
dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer.
analyzer.
* Rating with the low cut filter equipped amplifier.
Speaker System
Specification
ORDER NO. MD0803028CE
1 Assembling and Disassembling
“ATTENTION SERVICER”
Some chassis components may have sharp edges. Be careful when disassembling and servicing.
1. This section describes procedures for checking the operation and replacing the main components.
2. For reassembly after operation checks or replacement, reverse the respective procedures.
Special reassembly procedures are described only when required.
3. Select items from the following index when checks or replacement are required.
4. Refer to the Parts No. on the page of “Parts Location and Replacement Parts List” (Section 5), if necessary.
Below is the list of disassembly sections
• Disassembly of Stand
• Disassembly of Net frame assembly
• Disassembly of Tweeter (SP1)
• Disassembly of Woofer 1 (SP2)
• Disassembly of Woofer 2 (SP2)
• Disassembly of Rear cabinet assembly
• Disassembly of Terminal
• Disassembly of Net frame assembly
• Disassembly of Tweeter (SP1)
• Disassembly of Woofer 1 (SP2)
• Disassembly of Woofer 2 (SP2)
• Disassembly of Rear cabinet assembly
• Disassembly of Terminal
2
SB-PTX50EG / SB-HF100P
1.1. Disassembly of Stand
Step 1: Remove 3 screws.
Step 2: Remove stand.
1.2. Disassembly of Net frame
assemably
Follow (Step 1) to (Step 2) in item 1.1.
Step 1: Insert steel rule with cloth as shown.
Step 2: Apply force gently to push out the net frame assembly.
Caution: Do not exert too much force as it may damage the net
frame assembly.
frame assembly.
3
SB-PTX50EG / SB-HF100P
Step 3: Remove net frame assembly.
1.3. Disassembly of Tweeter (SP1)
Follow (Step 1) to (Step 2) in item 1.1.
Follow (Step 1) to (Step 3) in item 1.2.
Step 1: Remove 12 screws.
Step 2: Detach the front panel.
4
SB-PTX50EG / SB-HF100P
