PN-A601 (serv.man3) - Sharp Monitor Service Manual (repair manual). Page 21

PN-A601　INSTALLATION, ADJUSTMENT, SETTING

 2 – 2

■ HORIZONTAL INSTALLATION

Make the horizontal setting on the setting menu. 

1 ) Press and hold [SIZE] key for 5sec, and “F” is displayed on the left

upper corner of the screen.

2 ) Press [ 

T ] [ T ] [ S ] [ S ] keys.

3 ) When installing in FACE UP:

Press [ 

X ] to change VERTICAL to FACE UP.

When installing in FACE DOWN:

Press [ 

X ] to change VERTICAL to FACE DOWN.

4 ) Check to confirm the display, and turn OFF the main power. 

n

Only when installing in FACE UP, replace the fan cover with one
(PN-ZR31) which supports horizontal installation. 

n

For details of other installing conditions and notes, refer to the fol-
lowing description.
3Refer to Multi-Display Manual (Horizontal Installation)

n

Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/disconnecting cables. Also, read the

manual of the equipment to be connected.

n

Be careful not to mix up the input terminal with the output terminal when connecting cables. Mixing up the input and output terminals may cause
malfunctions and the other problems.

n

Images may not be displayed properly depending on the computer (video card) to be connected.

n

A screen with 1920 x 1080 resolution may not be displayed correctly on “PC RGB”. In this case, check the settings of your computer (video
card) to verify that input signals conform to specifications of this monitor.

n

If there is a check box to disable EDID in display control panel, check it when using “PC RGB”.

n

Use the automatic screen adjustment when a PC screen is displayed for the first time using “PC D-SUB” or “PC RGB”, or when the setting of

the PC is changed. The screen is adjusted automatically when “SELF ADJUST” in the OPTION menu is set to “ON”.

n

If the audio output from the playback device is connected directly to speakers or other devices, the video on the monitor may appear delayed

from the audio portion.
Audio should be played through this monitor by connecting the playback device to the monitor’s audio input, and connecting the monitor’s

audio output to the speakers or other devices.

n

The audio input terminals used in each input mode are factory-set as follows.

PC D-SUB

PC DVI-D
PC RGB

Audio input terminal

AV DVI-D

Audio1 input terminal

AV COMPONENT(BNC)
AV S-VIDEO

AV VIDEO (BNC)

Audio2 input terminal

AV COMPONENT (D-SUB)

AV VIDEO (D-SUB)

Audio input terminal

PC HDMI

AV HDMI

PC/AV HDMI input terminal