Read Sharp UP-600 / UP-700 (serv.man20) Service Manual online
CHAPTER 11. WRITING / READING THE MAC ADDRESS / FIRMWARE PROGRAM
(1) WRITING THE MAC ADDRESS &
FIRMWARE PROGRAM
1) Install the EPROM (Master ROM) to the UP-E10IN (IC5:IC
socket).
2) Set the following switches to the (Writing mode) on the UP-E10IN.
SW1 : [FLASH]
[EPROM]
SW2 : [GND]
[VCC]
3) Install the UP-E10IN to the ECR/POS (UP-600/700).
•
The ECR/POS (UP-600/700) power should be turned OFF.
4) Set the mode switch of the ECR/POS (UP-600/700) to SRV posi-
tion.
5) Turn ON the AC switch of the ECR/POS (UP-600/700).
6) Display : [SRV MODE]
Select the [5. DIAGNOSTIC] and press the ENTER key
Display : [5. DIAGNOSTIC]
Select the [TCP/IP] and press the ENTER key
Display : [TCP/IP]
Select the [MAC ADD&FIRM WRITE] and press the ENTER key
SW2
SW1:
IC5: IC socket
Normal mode
Writing mode
Normal mode
Writing mode
FLASH
EPROM
1
2
3
4
5
6
VCC
GND
SRV
0001
1
2
3
4
5
READING
SETTING
IRC SET UP
DOWN LOAD
DIAGNOSTIC
UP-600/700 DIAG V1.0A
PRODUCT & TEST
RAM & ROM & SSP
CLOCK & KEY & SWITCH
SERIAL I/O
DISPLAY & PRINTER
MCR & EFT & DRAWER
TCP/IP
TCP/IP & PRINTER DIAG
SELF Check
LOOPBACK Check
MAC ADDR & FIRM Ver. Read
MAC ADDR & FIRM WRITE
DATA Trans. (MA)
DATA Trans. (SA)
Click on the first or last page to see other UP-600 / UP-700 (serv.man20) service manuals if exist.