UP-600, UP-700 (serv.man20). UP600-700 Network Card Manual - Sharp ECR Service Manual (repair manual). Page 6

Read Sharp UP-600 / UP-700 (serv.man20) Service Manual online

(2) LAN CONTROLLER (RTL8019AS)
(2) -1. Features:
100-pin PQFP
Supports PnP auto detect mode
Compliant to Ethernet II and IEEE802.3 10Base5, 10Base2,
10BaseT
Software compatible with NE2000 on both 8 and 16-bit slots
Supports both jumper and jumperless modes
Supports Microsofts Plug and Play configuration for jumperless
mode
Supports Full-Duplex Ethernet function to double channel band-
width
Supports three level power down modes:
Sleep
Power down with internal clock running
Power down with internal clock halted
Built-in data prefetch function to improve performance
Supports UTP, AUI & BNC auto-detect
Supports auto polarity correction for 10BaseT
Support 8 IRQ lines
Supports 16 I/O base address options
--- and extra I/O address fully decode mode
Supports 16K, 32K, 64K and 16K-page mode access to BROM (up
to 256 pages with 16K bytes/page)
Supports BROM disable command to release memory after remote
boot
Supports flash memory read/write
16k byte SRAM built in
Use 9346 (64*16-bit EEPROM) to store resource configurations
and ID parameters
Capable of programming blank 9346 on board for manufacturing
convenience
Support 4 diagnostic LED pins with programmable outputs
(2) -2. General Description
The RTL8019AS is a highly integrated Ethernet Controller which of-
fers a simple solution to implement a Plug and Play NE2000 compat-
ible adapter with full-duplex and power down features.
With the three level power down control features, the RTL8019AS is
made to be an ideal choice of the network device for a GREEN PC
system. The full-duplex function enables simultaneously transmission
and reception on the twisted-pair link to a full-duplex Ethernet switch-
ing hub. This feature not only increases the channel bandwidth from
10 to 20 Mbps but also avoids the performance degrading problem
due to the channel contention characteristics of the Ethernet
CSMA/CD protocol.
The RTL8019AS provides the auto-detect capability between the inte-
grated 10BaseT transceiver, BNC and AUI interface. Besides, the
10BaseT transceiver can automatically correct the polarity error on its
receiving pair.
The RTL8019AS is built in with 16K-byte SRAM in a single chip. It is
designed not only to provide more friendly functions but also to save
the effort of SRAM sourcing and inventory.
(2) -3. Pin Configuration
LAN Controller
No.
CPU
Signal
name
I/O
Remarks
1
INT3
INT3
O
N.U. (Pull-Down)
2
INT2
INT2
O
N.U. (Pull-Down)
3
INT1
INT1
O
N.U. (Pull-Down)
4
INT0
/INTLAN
O
Interrupt to CPU
5
SA0
LA0
I
Address Bus
6
VDD
+5V
7
SA1
LA1
I
Address Bus
8
SA2
LA2
I
9
SA3
LA3
I
10
SA4
LA4
I
11
SA5
LA5
I
12
SA6
LA6
I
13
SA7
LA7
I
14
GND
GND
15
SA8
LA8
I
Address Bus
16
SA9
LA9
I
17
VDD
+5V
18
SA10
LA10
I
Address Bus
19
SA11
LA11
I
20
SA12
LA12
I
21
SA13
LA13
I
22
SA14
LA14
I
23
SA15
LA15
I
24
SA16
LA16
I
25
SA17
LA17
I
26
SA18
LA18
I
27
SA19
LA19
I
28
GND
GND
29
IORB
/MRD
I
Memory Read
81   BD3 [IOS0]
82   BD2 [IOS1] 
83   GND
84   BD1 [IOS2]
85   BD0 [IOS3]
86   GND
87   SD15
89   VDD
90   SD13
91   SD12
92   SD11
93   SD10
94   SD9
95   SD8
96   IOCS16B [SLOT16]
97   INT7 [IRQ15]
98   INT6 [IRQ12]
99   INT5 [IRQ11]
100   INT4 [IRQ10]
88   SD14
2   INT2 [IRQ4]
3   INT1 [IRQ3]
4   INT0 [IRQ2/9]
5  SA0
6   VDD
7   SA1
8   SA2
9   SA3
10   SA4
11   SA5
12   SA6
13   SA7
14   GND
15   SA8
29   IORB
28  GND
27   SA19
26   SA18
25   SA17
24   SA16
23   SA15
22   SA14
21   SA13
20   SA12
30   IOWB
19   SA11
18   SA10
17   VDD
16   SA9
64   AUI
63   LED2 [LED_TX]
62   LED1 [LED_RX] [LED_CRS]
61   LED0 [LED_COL] [LED_LINK]
60   LEDBNC
59   TPIN+
58   TPIN-
57   VDD
56   RX+
55   RX-
54   CD+
53   CD-
52   GND
51   X2
69   BA18 [BS2]
70   VDD
71   BA17 [BS3]
72   BA16 [BS4]
73   BA15
74   BA14 [PL0]
75   BCSB
76   EECS
77   BD7 [PL1][EEDO]
78   BD6 [IRQS0][EEDI]
79   BD5 [IRQS1][EESK]
80   BD4 [IRQS2]
RTL8019AS
1   INT3 [IRQ5]
68   BA19 [BS1]
67   BA20 [BS0]
66   BA21 [PNP]
50   X1
49   TX+
48   TX-
47   VDD
46   TPOUT-
45   TPOUT+
44   GND
43   SD7
42   SD6
39   SD3
38   SD2
37   SD1
36   SD0
34   AEN
33   RSTDRV
32   SMEMWB
31   SMEMRB
41   SD5
40   SD4
35   IOCHRDY
65   JP
Page of 20
Display

Click on the first or last page to see other UP-600 / UP-700 (serv.man20) service manuals if exist.