WV-CP160 - Panasonic Video Monitoring Service Manual (repair manual). Page 7

WV-CP160

– 5 –

An initial setting of the Switches on the Left side Panel of
the WV-CP160 are as follows:
Detail Level Selector

(SOFT-SHARP)

 . . . . . . . . . . . . . .

SHARP

Microphone Selector

(MIC OFF-ON)

 . . . . . . . . . . . . . . . .

OFF

The adjustments should be done with this initial setting,
unless otherwise specified.

The adjustments should be done after 10 minutes warm
up.

Refer to the Location of the Test Points and Adjusting
Controls on the page 11.

Mount the ALC Lens WV-LA9C3B on the Camera.
Set the Radiation Chart.
Aim the Camera at the Radiation Chart distance of 10m.
Set the Lens Focus Ring so that the Lens Focus positions
approx. 9mm in front from infinity.
Referring to Fig. 5-1, loosen the Focus-Fixing Screw that
secure the Flange-back Adjusting Ring.
Adjust the Flange-back Adjusting Ring to obtain best
focal point.

Set the VP/STD Camera Selection Switch on the rear

panel according to the camera. 

Set to VP Camera position for VP Multiplexed Camera.

Set to STD Camera position for Standard Camera. 

Make a copy of following necessory files to your comput-
er from original floppy disk of the Remote E.V.R.
Adjustment Kit.

1. Confirm that the CONFIG.SYS file on your computer

contains DEVICE=ANSI.SYS.

2. Insert floppy disk containing E.V.R.adjustment program

into your floppy drive (for example,drive:A) and type A:

3. At the prompt, type CD IBMPC and press ENTER key.

4. Type COPY RADJ.EXE B: and press ENTER key.

5. Type CD\ and press ENTER key.

6. Type CD PAL and press ENTER key.

7. Type COPY CP160E.SEQ B: and press ENTER key.

8. After completing installation of program, you are ready

to use the E.V.R. adjustment program.

Focus-Fixing Screw

Flange-back
Adjusting Ring

Tighten the Focus-Fixing Screw that secure the Flange-
back Adjusting Ring carefully.
Change the ALC Lens to WV-LA9C3A from WV-LA9C3B.